Zanussi ZRA25600WA Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник Zanussi ZRA25600WA. Zanussi ZRA25600WA 24 сторінки.
Друкувати сторінку
the appliance, please turn to the vendor, to our
customer service or to the nearest Service Cen-
tre
Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted as shown in
the figure.
1. Fit the spacers
into the holes.
Make sure that
the arrow (A) is
positioned as
shown in the pic-
ture.
2. Turn counter-
clockwise the
spacers through
45° until they
lock into place.
Levelling
When placing the ap-
pliance ensure that it
stands level. This can
be achieved by two
adjustable feet at the
bottom in front .
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
www.zanussi.com
A
45˚
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and the
wall unit must be at least 100 mm . Ideally, how-
ever, the appliance should not be positioned
below overhanging wall units. Accurate levelling
is ensured by one or more adjustable feet at the
base of the cabinet.
If the cabinet is placed in a corner and the side
with the hinges facing the wall, the distance be-
tween the wall and the cabinet must be at least
10 mm to allow the door to open enough so
that the shelves can be removed.
Warning!
min.
100 mm
15 mm
15 mm
It must be possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
9