Clarke Woodworker CPT800 Посібник з експлуатації та обслуговування - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник з експлуатації та обслуговування для Електроінструмент Clarke Woodworker CPT800. Clarke Woodworker CPT800 18 сторінок. Planer/thicknesser
Також для Clarke Woodworker CPT800: Інструкція з експлуатації та обслуговування (18 сторінок)
Друкувати сторінку
First, ensure the machine is switched OFF and isolated from the mains supply.
1. Turn the cutter height adjuster so that it registers zero. i.e turn the knob
clockwise so that the depth of cut, registered on the scale, is zero.
1. Remove the Angle Fence.
2. Raise the Cutter Guard arm.
3. Turn the cutter block to reveal the four hex. socket head screws securing the
cutter blade, then carefully remove them.
4. Turn the cutter block by 180 degrees and repeat the process.
ALWAYS hone/replace cutter blades as a pair.
5. Replace in reverse order, and, using a straight edge, ensure the cutting edges
are level and exactly in line with the table when they are at 12 o'clock - see
Fig.7. Tighten the securing screws taking care not to overtighten or damage
the hex. sockets..
NOTE: It is recommended that sharpening is done professionally, using a jig, as
blades must be sharpened as a pair to ensure they are correctly balanced. This
avoids the possibility of vibration due to inbalanced cutters rotating at speed.
Periodically.
•
Wipe both the infeed and outfeed rollers with a damp cloth to remove all
traces of contaminants.
•
Wax the Thicknesser table frequently to ensure a smooth and reliable feed.
•
Inspect the Kickback pawls before each operation to ensure they are intact
and working properly. They should hang normally and loosely.
•
Remove the front cover - 3 dome head nuts, and lightly oil all pivots, linkages
and bearings with good quality machine oil. Ensure the enclosure and all
components are perfectly clean before replacing the cover.
11
Fig. 7