Zanussi ZRB33104XA Посібник користувача - Сторінка 23
Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник Zanussi ZRB33104XA. Zanussi ZRB33104XA 44 сторінки.
Також для Zanussi ZRB33104XA: Посібник користувача (16 сторінок)
Друкувати сторінку
Problem
The temperature in the re-
frigeration is too high.
The temperature in the
freezer is too high.
The appliance does not op-
erate.
The lamp does not work.
If your appliance is still not working properly af-
ter making the above checks, contact the After
Sales Centre.
Replacing the lamp
1. Disconnect the appliance.
2. Gently move the transparent cover up and
down and at the same time unhook it in the
direction of the arrows .
3. Replace the lamp with an original spare
part or as an alternative it is possible to use
the Osram PARATHOM SPECIAL T26 0.8
Watts bulb. Another alternative is to use an
incandescent bulb lamp specifically de-
signed for household appliances (see also
SAFETY INFORMATION chapter) with
maximum power not exceeding the light dif-
fuser indication.
4. Install the lamp cover.
www.zanussi.com
Possible cause
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in the
appliance.
Products are too near to each other. Store products so that there is cold
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same time.
Make sure that there is cold air circu-
lation in the appliance.
air circulation.
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact a
qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
5. Connect the appliance to the mains socket.
6. Open the door. Make sure that the lamp
turns on.
1
2
1
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Solution
23