Zanussi ZRB834NW Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник Zanussi ZRB834NW. Zanussi ZRB834NW 16 сторінок.

Друкувати сторінку

Electrical Connection

Caution! Any electrical work required to install

this appliance should be carried out by a qualified

electrician or competent person.

Warning! This appliance must be earthed.

The manufacturer declines any liability should

these safety measures not be observed.

Important! The wires in the mains lead are coloured

in accordance with the following code:

Green and Yellow:

Brown:

Blue:

As the colours of the wires in the mains lead of this

appliance may not correspond with the coloured mark-

ings identifying the terminals in your plug, proceed as

follows:

1. Connect the wire coloured green and yellow to the

terminal marked either with the letter "E" or by the

earth symbol

or coloured green and yellow.

2. Connect the wire coloured blue to the terminal ei-

ther marked with the letter "N" or coloured black.

3. Connect the wire coloured brown to the terminal

either marked with the "L" or coloured red.

4. Check that no cut, or stray strands of wire is present

and the cord clamp

sheath.

Earth

Live

Neutral

is secure over the outer

5. Make sure the electricity supply voltage is the same

as that indicated on the appliance rating plate.

6. Switch on the appliance.

The appliance is supplied with a 13 amp plug fitted

. In the event of having to change the fuse in the

plug supplied, a 13 amp ASTA approved (BS 1362)

fuse must be used.

Warning! A cut off plug inserted into a 13 amp

socket is a serious safety (shock) hazard. Ensure

that it is disposed of safely.

Rear spacers and levelling

In the bag with the docu-

mentation, there are two

spacers which must be

fitted as shown in the fig-

ure.

Slacken the screws and

insert the spacer under

the screw head, then

tighten again the screws.

Removing the shelf holders

Your appliance is equipped with shelf retainers that

make it possible to secure the shelves during trans-

portation.

To remove them proceed as follows:

1. Move the shelf holders in the direction of the arrow

(A).

When placing the appli-

ance ensure that it

stands level. This can be

achieved by two adjusta-

ble feet at the bottom in

front.