Zanussi ZRT 163W Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Холодильник Zanussi ZRT 163W. Zanussi ZRT 163W 16 сторінок.

Ventilation Requirements

The appliance must have adequate ventilation to ensure

correct operation.

Diagram shows the ventilation requirements when

installed:

A* Under a worktop, or cupboard.

The clearance space of 10 cm above the appliance

may be reduced to 5 cm providing a clearance space

2.5 cm is left on either side of the appliance.

When freestanding

The appliance must be level. Level the appliance by

adjusting the two adjustable feet (1) at the front of the

appliance.

If required the washer (2) can be removed.

If required the opening direction of the door can be

changed as follows:

To reverse the bottom hinge assembly proceed as fol-

lows:

Disconnect the appliance from the electricity supply.

Tilt the appliance backwards, resting the top edge of

the appliance on a stool or something similar.

Unscrew the adjustable feet situated on both sides at

the front (2 pieces). Remove the lower door hinge

plate by unscrewing the 2 retaining screws.

Remove the hinge pin from the bottom of the door.

Slot the hinge pin into the hole in the hinge plate and

relocate the hinge assembly to the opposite location

and refit using the retaining screws.

Put the cabinet in the upright position.

To reverse the top hinge assembly proceed as follows:

Remove the 2 worktop retaining screws from the

back of the appliance.

Slide the worktop towards the rear and lift clear of the

appliance.

Remove the 2 upper hinge plate retaining screws.

Remove the hinge plate from the top of the door.

Unscrew the hinge pin from the hinge plate and re-

insert on the opposite side of the pate.

Rotate the hinge assembly 180° and insert the hinge

assembly into the opposite location.

Refit the 2 hinge plate retaining screws.

Relocate the worktop and refit the worktop retaining

screws.