Zanussi ZRX307W Посібник користувача - Сторінка 19

Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник Zanussi ZRX307W. Zanussi ZRX307W 44 сторінки.

Друкувати сторінку

To change the opening direction of the door, do these

steps:

1. Remove the plug from

the power socket.

2. Remove the top hinge

cover.

3. Unscrew the 2 retaining

screws, and remove the

hinge from the appliance.

4. Take the door off.

Do a final check to make sure that:

• All screws are tightened.

• The door opens and closes correctly.

If the ambient temperature is cold (i.e. in Winter), the

gasket may not fit perfectly to the cabinet. In that case,

wait for the natural fitting of the gasket.

In case you do not want to carry out the above men-

tioned operations, contact the nearest After Sales Serv-

ice Force. The After Sales Service specialist will carry

out the reversibility of the doors at your cost.

Electrical connection

Before plugging in, ensure that the voltage and frequen-

cy shown on the rating plate correspond to your domes-

tic power supply.

Environmental concerns

The symbol

on the product or on its packaging

indicates that this product may not be treated as

household waste. Instead it should be taken to the

5. Remove the screw fix-

ing the lower door hinge

and the other screw fixing

the lower door hinge and

the foot. Then remove the

door hinge and the foot as

shown in the Figure.

6. Loosen the screw fixing

the foot opposite the lower

door hinge in order to re-

move the foot.

7. Fix the door hinge and

the corresponding foot on

the opposite side and then

the other loosened foot at

the former place of the

door hinge as shown in

the Figure.

8. Please make sure to

place the lower foot below

the door hinge. The lower

foot is recognizable by its

4 ribs on the outer surface.

9. Fix the door onto the

lower hinge pin.

10. To fit top door hinge,

remove the plastic blank-

ing plugs carefully, and re-

fit them in the holes left by

the hinge retaining screws.

The appliance must be earthed. The power supply cable

plug is provided with a contact for this purpose. If the

domestic power supply socket is not earthed, connect

the appliance to a separate earth in compliance with cur-

rent regulations, consulting a qualified electrician.

The manufacturer declines all responsibility if the above

safety precautions are not observed.

This appliance complies with the E.E.C. Directives.

appropriate collection point for the recycling of

electrical and electronic equipment. By ensuring this

product is disposed of correctly, you will help prevent

potential negative consequences for the environment

11. Refit the top hinge us-

ing the 2 retaining screws,

taking care that the edge

of the door is parallel with

side of the cabinet.

12. Replace the hinge cov-

er.

13. Relocate the handle

and the plastic plugs to

the opposite side.

14. Level the appliance,

wait for at least four hours

and then connect it to the

power socket.