Zanussi ZUA12420SA Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник Zanussi ZUA12420SA. Zanussi ZUA12420SA 16 сторінок.
Також для Zanussi ZUA12420SA: Інструкція з монтажу (20 сторінок)
Друкувати сторінку
Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig-
erator.
Water flows on the ground. There is too much water in the air
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
The temperature in the re-
frigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
www.zanussi.com
Possible cause
The product temperature is too
high.
The room temperature is too high.
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
deflector.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each oth-
er.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not set
correctly.
Solution
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Clean the air deflector.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same
time.
Make sure that there is cold air circu-
lation in the appliance.
Store products so that there is cold
air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
9