Clarke ZX-R Pro Series Інструкція з експлуатації та технічного обслуговування - Сторінка 13

MAINTENANCE

Before starting any cleaning or maintenance, always ensure the tool is

isolated from the electrical supply by switching off and removing the plug

from the power socket.

CLEANING

1. Ensure all air ventilation slots are clear, (Use compressed air to clean the

tool if possible. Always wear protective goggles when cleaning with

compressed air).

2. Clean the exterior of the tool with a soft cleaning cloth. Never use any

chemicals or harsh abrasives. Avoid using solvents when cleaning plastic

parts, which may be susceptible to damage from various types of

commercial solvents.

GENERAL MAINTENANCE

• All bearings etc, in this tool are lubricated with a sufficient amount of

high grade lubricant for the tools lifetime under normal operating

conditions, therefore no further lubrication is necessary.

• The carbon brushes in the tool will eventually wear down to such an

extent that sparks will be noticed inside the tool and its performance

will deteriorate. Brushes are a consumable spare which should be

replaced by your Clarke dealer or power tool repairer.

• Refer to your CLARKE dealer if internal maintenance is required.

The Multi-Function Tool Accessory Kit - (Part No 6462205) includes the following

and is available from your CLARKE dealer.

1 x Semi-circular sanding blade (Diameter 65mm)

6 x Sanding sheets (2 x 80 grit) (2 x 120 Grit) (2 x 240 Grit)

1 x Straight Blade (10 mm)

1 x Straight Blade (20 mm)

2 x Straight Blade (32.5 mm)

1 x Semi-circular Blade (Diameter 87 mm)

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]