Zanussi ZOF35712X Посібник користувача - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник користувача для Духовка. Zanussi ZOF35712X. Zanussi ZOF35712X 20 сторінок.
Також для Zanussi ZOF35712X: Посібник користувача (20 сторінок), Посібник користувача (24 сторінок)

Друкувати сторінку

Catalytic cleaning

CAUTION!

Do not clean the catalytic surface

with oven sprays, abrasive cleaning

agents, soap or other cleaning

agents. This will damage the

catalytic surface.

Spots or discolouration of the

catalytic surface have no effect on

catalytic properties.

WARNING!

Keep children away when you clean

the oven at a high temperature. The

oven surface becomes very hot and

there is a risk of burns.

CAUTION!

Always turn the oven light on while

using the catalytic cleaning (if

applicable).

Before activating the catalytic

cleaning remove all the accessories

from the oven.

The walls with a catalytic coating are self-

cleaning. They absorb fat which collects on the

walls while the appliance operates.

To support the self-cleaning procedure, heat

the empty oven on a regular basis.

1. Clean the oven floor with warm water and

washing up liquid, then dry it.

2. Set the function

3. Set the temperature to 250ºC and let oven

operate for 1 hour.

4. When the appliance is cool, clean it with a

soft and moist sponge.

Removing and installing the door

You can remove the door and the internal glass

panels to clean it. The number of glass panels is

different for different models.

WARNING!

Be careful when you remove the

door from the appliance. The door is

heavy.

1. Open the door fully.

if applicable. If not, set

2. Fully lift up the clamping levers (A) on the

two door hinges.

3. Close the door until it is at an angle of

approximately 45°.

45°

4. Hold the door with one hand on each side

and pull it away from the appliance at an

upwards angle.

5. Put the door with the outer side down on a

soft cloth on a stable surface. This is to

prevent scratches.

6. Hold the door trim (B) on the top edge of

the door at the two sides and push inwards

to release the clip seal.

CAUTION!

Rough handling of the glass,

especially around the edges of the

front panel, can cause the glass to

break.

7. Pull the door trim to the front to remove it.

8. Hold the door glass panels on their top

edge one by one and pull them up out of

the guide.