Zanussi ZOG10311 Посібник користувача - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник користувача для Духовка. Zanussi ZOG10311. Zanussi ZOG10311 24 сторінки.

Друкувати сторінку

1. Product Description

The gas supply ramp is on the rear side of the

appliance.

WARNING!

Do not use rubber flexible pipes!

Do not fully put the oven into the built-in cabinet

(approximately 30 cm).

Connection with a flexible metallic pipe or

a rigid metallic pipe:

A. Gas supply ramp, end of shaft with ramp

B. Washer

C. Elbow

Put the supplied gasket between the pipe and

the gas supply ramp. Turn the pipe to the 1/2"

gas supply ramp.

1. Use a 22 mm spanner to tighten the nuts.

Keep the gas supply ramp in the correct

position. Do not apply force to the gas

supply circuit.

WARNING!

Do not use a flame to check for

leaks!

2. Fully move the oven into the built-in cabinet.

WARNING!

Do not squeeze the gas supply

ramp and the pipe when you

move the oven into the built-in

cabinet.

3. Seal the connection correctly. Use a leak

detection to control it.

Adjustment to different types of gas

Let only an authorized person do the

adjustment to different types of gas.

If the appliance is set for natural gas

you can change it to liquid gas, with

the correct injectors.

The gas rate is adjusted to suit.

B C

WARNING!

Before you replace the injectors,

make sure that the gas knobs are in

the Off position. Disconnect the

appliance from the electrical supply.

Let the appliance cool down. There

is a risk of injury.

Gas grill injector replacement

1. Release the screws which keep the grill

burner in position (A).

2. Carefully move forward the burner off the

injector support. Slowly move it down. Do

not apply force to the wire of the spark plug

connector (B) and to the thermocouple

conductor (C).

3. Release the burner injector (D) with a 7 mm

socket spanner and replace it with a

different one which is necessary for the type

of gas you use.

Refer to "Technical information" chapter.

4. Assemble the burner in a reverse sequence.

Before you fix the screw, make sure that the

burner is pushed correctly to the back

panel.

Test the grill injectors.

Oven injector replacement

1. Remove the bottom plate of the oven cavity

(A) to get access to the oven burner (B).