Zanussi ZOP37902 Посібник користувача - Сторінка 17
Переглянути онлайн або завантажити pdf Посібник користувача для Духовка. Zanussi ZOP37902. Zanussi ZOP37902 24 сторінки. Product manaul
Також для Zanussi ZOP37902: Посібник користувача (24 сторінок), Посібник користувача (28 сторінок)
Друкувати сторінку
Removing the shelf supports
1
Pull the front of
the shelf support
away from the side
wall.
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
The rounded ends of the shelf supports
must point to the front.
Pyrolysis
Warning! The appliance becomes very
hot. There is a risk of burns.
Caution! If a hob is installed with the
appliance, do not use it at the same times
as the Pyrolysis function. It can cause damage
to the appliance.
1. Remove the removable shelf supports (if
applicable) and accessories from the appli-
ance. Refer to "Removing the shelf sup-
ports".
Caution! Do not let the removable shelf
supports stay in the appliance during the
cleaning procedure. There is a risk of damage.
2. Remove the worst dirt manually.
3. Fully close the oven door.
The cleaning procedure cannot start if you
do not close the oven door.
4. Set the function Pyrolysis. Refer to "Oven
functions".
5. When
flashes, press + or - to set the
necessary procedure:
www.zanussi.com
2
1
2
Pull the rear end
of the shelf support
away from the side
wall and remove it.
– P1 - if the oven is not very dirty. The pro-
cedure is 1 h long.
– P2 - if the oven is more dirty. The proce-
dure is 1 h 30 min long.
6. Press
to start the procedure. You can
use the End function to delay the start of
the cleaning.
When the oven is at the set temperature,
the door locks. The display shows the sym-
bol
and the bars of the heat indicator.
To stop Pyrolysis before it is completed,
turn the knob for the oven functions to the
off position.
When Pyrolysis is completed, the display
shows the time of day. The oven door stays
locked. When the appliance is cool again, an
acoustic signal sounds and the door unlocks.
During the Pyrolysis the oven lamp is off.
Cleaning reminder
To remind you that Pyrolysis is necessary, PYR
flashes in the display for 10 seconds after each
activation and deactivation of the appliance.
The cleaning reminder goes off the
display:
• After the end of the Pyrolysis function
• If you press + and - at the same time while
PYR flashes in the display.
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of electrical
shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deacti-
vate the circuit breaker.
Put a cloth on the bottom of the oven to
prevent damage to the oven light and
glass cover.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
17