Zanussi FA831E Посібник користувача - Сторінка 17

Переглянути онлайн або завантажити pdf Посібник користувача для Пральна машина Zanussi FA831E. Zanussi FA831E 28 сторінок. Washing machine fa831e; fa1031e

Друкувати сторінку

7. OPTIONAL! Select, if required,

"8H/4H INICIO RETARDADO"

option button

Push "8H/4H INICIO RETARDADO" button as many

times as necessary until the corresponding light to

the required delay (8 H, 4 H) comes on.

8. Start the machine

Before starting the machine check that:

• the appliance is plugged in.

• the water supply tap is turned on.

• the drain hose is correctly and securely positioned.

• the door and the detergent dispenser drawer are

closed.

To start the selected programme, push

INICIO / PAUSA button; the corresponding light will

stop flashing and will remain lit until the end of the

programme.

If "8H/4H INICIO RETARDADO" option has been

chosen, the machine will begin the countdown.

9. Modification of a running

washing programme

Once the programme has started, it only can be

modified by turning the programme selector dial to

" and afterwards the new programme can be

chosen.

The washing water remains in the tub, provided that

the machine does not reach the rinse phase, since,

in this case, the machine drains it automatically.

Start the new programme by pressing

INICIO / PAUSA button.

10. Interrupting a programme

Depress INICIO / PAUSA button to interrupt a

running programme, the corresponding light will

begin flashing. Press this button again to re-start the

programme.

11. Opening the door after the

programme has started

Firstly, stop the machine by pressing

INICIO / PAUSA button.

After about two or three minutes the door can be

opened.

If the door does not open , this means that the

temperature of the water is too high, that the water

level exceed the lower limit of the door (which could

cause overflowing) or that the drum is spinning.

If the door cannot be opened but you need to open it,

switch the machine off by turning the selector dial to

". After approximately two or three minutes the

door can be opened. (PAY ATTENTION TO THE

WATER LEVEL AND TEMPERATURE!)

12. At the end of the programme

The machine stops automatically.

Release of the lock is indicated when FIN light

comes on.

Turn the programme selector dial to position "

switch the machine off.

Remove the laundry from the drum and carefully

check that the drum is empty.

If you do not intend to put in another wash, turn off

the water tap. Leave the door open to prevent from

forming mildew and unpleasant smells.

ATTENTION!

If the

RINSE HOLD option has been selected,

the last rinse water does not drain. To drain the

water, carry out the following steps:

1. Turn the programme selector dial to "

2. Select

DRAIN or

3. Press INICIO / PAUSA button

" to

SPIN programme.