Zanussi FE 904 NN Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Пральна машина Zanussi FE 904 NN. Zanussi FE 904 NN 22 сторінки. Washing machine fe 904 nn

Друкувати сторінку

1. Control Panel

FABRIC button

, then press RESET three times

in order to select the DRAIN

DRAIN light

will remain lit).

OPTIONS

button

Press this button to select the following options:

• PREWASH

: select this option if you wish your

laundry to be prewashed before the main wash

(not available for wool/handwash).

The prewash ends with a short spin at 650 rpm in

programmes for cotton and synthetic fabrics,

whereas in the programme for delicate fabrics the

water is only drained.

• ECONOMY

: this option can be selected only

for cottons and synthetics lightly or normally

soiled with a temperature 40°C or higher. The

washing time will be prolonged and the washing

temperature will be reduced.

• SUPER RINSE

: this option can be selected

with all programmes except the wool/handwash

programmes. The machine will add 2 additional

rinses to the selected programme. This option is

recommended for people who are allergic to

detergents, and in areas where the water is very

soft.

7 START/PAUSE button

This button has two functions:

• Start: after you have selected the desired

programme and options, press this button to start

the washing machine. The light above the button

will stop flashing and remain lit.

• Pause: when you press this button again, the

programme in progress is interrupted. The light

above the button will start flashing. To restart the

programme, press the button again.

Important! You must set the washing machine to

PAUSE before you make any change in the

programme in progress.

8 SKIP/RESET button

At the end of a programme, you must press this

button once or repeatedly, in order to clear the

contents of the memory; otherwise, the next time

you switch the washing machine on, the pilot lights

relevant to the end of the previous cycle will go on.

You can also press the RESET button to exclude

one or several phases of the programme which is

running, as indicated below.

position (only the

- set the washing machine to PAUSE by pressing

the START/PAUSE button (the relevant light will

flash);

- press the RESET button once or several

times, until the required phase(s) is(are) cancelled

(the light next to the symbol of the phase(s) will go

out).

Example:

This button allows you also to select special

programmes, such as RINSES, SPIN and DRAIN.

• If the machine is already switched on because it

has just performed a washing programme, proceed

as follows:

- depress RESET once or repeatedly to cancel the

previously performed programme (all the phase

indicator lights must be off);

- select the type of fabric by means of the relevant

button;

- select the special programme:

• RINSES

AND SPIN

Depress RESET once, the pilot light

goes out.

• SPIN

Depress RESET twice, the pilot lights WASH

and RINSES

go out.

•DRAIN

Depress RESET three times, the pilot lights

WASH

, RINSES

and

goes on.

In this case, the spin

(at the speed provided

for the selected type of

fabric) will be

performed.

(WASH)

and SPIN

go out