Zanussi DCE 5655 Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Посудомийна машина Zanussi DCE 5655. Zanussi DCE 5655 20 сторінок. Zanussi instruction book dishwasher dce 5655

Друкувати сторінку

Adjusting the water softener

To prevent limescaling on the dishes and to the interior of the

dishwasher, the dishes must be washed with soft water.

This dishwasher is equipped with a water softener, where tap-

water which is harder then 4 °d (german degree) is softened.

Adjust the water softener according to the table below for the

water hardness level for your area.

Water hardness level

i °d

> 24

18 - 24

12 - 18

4 - 12

below 4

In both of the following settings the dishwasher must be switched off and all programmes completed.

See page 9 for the programme cycles.

1. Press the water softener and functions buttons

simultaneously and hold them pressed in, then

also press in the On/Off button.

2. When the lamps for the water softener and

functions buttons starts to ﬂash, you can let go

of the buttons.

3. Press the water softener button once. At ﬁrst the

lamp will be solid, then it starts to ﬂash.

- The number of ﬂashes are equivalent with the

set water hardness level.

- This sequence of ﬂashes is repeated several

times after a few seconds pause.

4. The water hardness level is raised by 1 step

every time you press the water softener button.

After hardness level 5 comes hardness level 1.

5. Press the On/Off button when the required water

hardness level is selected. This saves the selection.

If the setting 1 is chosen, the salt indicator lamp

is not lit.

1) german degree of measurement for the water

hardness

2) millimol, internationel unit for water hardness

*) factory setting

i mmol/l

4,2

3,2 - 4,2

2,1 - 3,2

0,7 - 2,1

below 0,7

- 7 -

Contact your local Water Authority to ﬁnd the

exact water hardness level for your area.

The water softener has 5 settings:

Setting on the

water softener

no salt is needed

If dishwasher detergent with rinse aid is used,

you can switch off the lamp that indicates that

the rinse aid dispenser is empty.

1. Press the water softener and functions buttons

simultaneously and hold them pressed in, then

also press in the On/Off button.

2. When the lamps for the water softener and

functions buttons starts to ﬂash, you can let go

of the buttons.

3. Press the functions button once. The lamps for

the functions button and ended programme cycle

starts to ﬂash. Press the button once more and

the light for the ended programme cycle goes out.

Now the function for the rinse aid control light

is off.

4. Press out the On/Off button to complete the setting.

To reset the function, follow steps 1 and 2 above

and then press the functions button twice, until

the lights for the functions button and for ended

programme cycle begin to ﬂash again.

Number of

light ﬂashes