Zanussi ZDT41 Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина Zanussi ZDT41. Zanussi ZDT41 16 сторінок.

Друкувати сторінку

2. Release the programme selection/cancel button to

cancel the washing programme.

At this time you can do these steps:

1. Switch off the appliance.

2. Set a new washing programme.

Fill the detergent dispenser with detergent before you set

a new washing programme.

Interrupting a washing programme

Open the door.

• The programme stops.

Close the door.

• The programme continues from the point of interrup-

tion.

End of the washing programme

Switch off the appliance in these conditions:

• The appliance stops automatically.

Care and cleaning

Warning! Switch the appliance off before you clean

the filters.

Cleaning the filters

Important! Do not use the appliance without the filters.

Make sure that the installation of the filters is correct.

Incorrect installation will cause unsatisfactory washing

results and damage to the appliance.

Fully clean the filters A, B

and C below running wa-

ter.

• The audible signals for the end of the programme op-

erate.

1. Open the door.

– The end indicator light comes on.

– The programme indicator light stays on.

2. Press the on/off button.

3. For better drying results, keep the door ajar for some

minutes before you remove the dishes.

Let the dishes cool down before you remove them from

the appliance. Hot dishes are easily damaged.

Removing the load

• First remove items from the lower basket, then from

the upper basket.

• There can be water on the sides and door of the appli-

ance. Stainless steel becomes cool more quickly than

the dishes.

To remove filters B and C,

turn the handle approxi-

mately 1/4 anticlockwise.

Put the flat filter A in the

bottom of the appliance.

Install the flat filter cor-

rectly under the two

guides D.

Remove the flat filter A

from the bottom of the ap-

pliance.

Put the filter system in po-

sition. To lock the filter

system, turn the handle

clockwise until it locks in

position.