Zanussi ZGF 642 CTN Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня Zanussi ZGF 642 CTN. Zanussi ZGF 642 CTN 16 сторінок. Gas hobs

Друкувати сторінку

Building In

Building over a cupboard or

drawer

If the hob is to be installed above a cupboard or drawer it

will be necessary to fit a heat resistant board below the

base of the hob on the underside of the work surface.

ON/OFF SWITCH

FLEX

OUTLET

FO 0763

Building over a kitchen unit with

door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the bottom

of the hob which can be heated when it is operated. The

recommended solution is shown in diagram 3.

The panel fitted under the hob ("a") should be easily

removable to allow easy access if technical assistance

is needed. The space behind the kitchen unit ("b") can

be used for connections.

Fitting the Hob into the worktop

Carry out the building in of the hob as follows:

•

put the seals supplied with the hob, on the

edges of the cut out: place them along the

side edges and at 8 mm from the front and

rear edge, as shown in the diagram, taking

care that the seals meet without overlapping;

•

place the hob in the cut out, taking care that it

is centred;

•

fix the hob with the relevant fixing clamps and

screws, as shown in the diagram. When the

screws have been tightened, the excess seal

can be removed.

The edge of the hob forms a double seal which prevents

the ingress of liquids.

It is also recommended to carry out the electrical

connection to the hob as shown in diagrams 1 and 2.

ON/OFF SWITCH

FLEX

OUTLET

FO 2564

FO 0199

FO 2044

Dimensions are given in mm.

Seal