Zanussi ZGG 782 CT Інструкція з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня Zanussi ZGG 782 CT. Zanussi ZGG 782 CT 32 сторінки.

Operation

Lighting the burners
Lighting the burners
Lighting the burners
Lighting the burners
Lighting the burners
For easier lighting,
For easier lighting,
For easier lighting,
For easier lighting,
For easier lighting,
putting a pan on the pan support.
putting a pan on the pan support.
putting a pan on the pan support.
putting a pan on the pan support.
putting a pan on the pan support.
To light a burner:
turn the relevant knob anti-clockwise to
maximum position (
ignite the burner.
After lighting the flame, keep the knob
pushed down for about 5 seconds
will allow the "thermocouple" (Fig.1 letter
D) to be heated and the safety device to be
switched off, otherwise the gas supply
would be interrupted.
Then, check the flame is regular and adjust
it as required.
To put the flame out, turn the knob to the
symbol
"
If the burner does not ignite, turn the control
knob to zero, and try again.
If you cannot light the flame even after several
attempts, check the "cap" (Fig.1- lett. A A A A A ) and
the"crown" (Fig.1- lett. B B B B B ) are in the correct
position.
Do not keep the control knob pressed for more than 15 seconds.
Do not keep the control knob pressed for more than 15 seconds.
Do not keep the control knob pressed for more than 15 seconds.
Do not keep the control knob pressed for more than 15 seconds.
Do not keep the control knob pressed for more than 15 seconds.
If the burner does not light even after 15 seconds, release the
If the burner does not light even after 15 seconds, release the
If the burner does not light even after 15 seconds, release the
If the burner does not light even after 15 seconds, release the
If the burner does not light even after 15 seconds, release the
control knob,
control knob,
control knob,
control knob,
control knob,
minute before trying to light the burner again.
minute before trying to light the burner again.
minute before trying to light the burner again.
minute before trying to light the burner again.
minute before trying to light the burner again.
If the burner accidentally goes out, turn the control knob to the
If the burner accidentally goes out, turn the control knob to the
If the burner accidentally goes out, turn the control knob to the
If the burner accidentally goes out, turn the control knob to the
If the burner accidentally goes out, turn the control knob to the
"off" position and wait for at least 1 minute before trying to light
"off" position and wait for at least 1 minute before trying to light
"off" position and wait for at least 1 minute before trying to light
"off" position and wait for at least 1 minute before trying to light
"off" position and wait for at least 1 minute before trying to light
the burner again.
the burner again.
the burner again.
the burner again.
the burner again.
When switching on the mains, after installation or a power cut, it is quite
normal for the spark generator to be activated automatically.
In the absence of electricity, ignition can occur without the electrical
In the absence of electricity
In the absence of electricity
In the absence of electricity
In the absence of electricity
device; in this case, approach the burner with a flame, push the relevant
knob down and turn it anti-clockwise until it reaches the maximum position.
If the control knobs become difficult to turn, please contact your local
Service Force Centre.
8
proceed before
proceed before
proceed before
proceed before
proceed before
), then push it down to
5 seconds
5 seconds. This
5 seconds
5 seconds
".
turn it the "off" position and wait for at least one
turn it the "off" position and wait for at least one
turn it the "off" position and wait for at least one
turn it the "off" position and wait for at least one
turn it the "off" position and wait for at least one
Triple crown burner
A A A A A - Burner cap
B B B B B - Burner crown
C C C C C - Ignition electrode
D D D D D - Thermocouple
A
B
D
C
A
B
D
C
Fig. 1