Zanussi ZGG62411 Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Варильна поверхня Zanussi ZGG62411. Zanussi ZGG62411 28 сторінок. Zanussi zgg62411 gas hob user manual
Також для Zanussi ZGG62411: Посібник користувача (28 сторінок)

Друкувати сторінку

Important! Make sure that the gas supply

pressure of the appliance obeys the

recommended values. The adjustable

connection is fixed to the comprehensive ramp

by means of a threaded nut G 1/2". Screw the

parts without force, adjust the connection in the

necessary direction and tighten everything.

A) End of shaft with nut

B) Washer

C) Elbow

Liquid gas

Use the rubber pipe holder for liquid gas. Al-

ways engage the gasket. Then continue with

the gas connection.

The flexible pipe is prepared for apply when:

– it can not get hot more than room tempera-

ture, higher than 30°C;

– it is no longer than 1500 mm;

– it shows no throttles;

– it is not subject to traction or torsion;

– it does not get in touch with cutting edges or

corners;

– it can be easily examined in order to make

sure its condition.

The control of preservation of the flexible pipe

consists in checking that:

– it does not show cracks, cuts, marks of burn-

ings on the two ends and on its full length;

– the material is not hardened, but shows its

correct elasticity;

– the fastening clamps are not rusted;

– expired term is not due.

If one or more defects are visible, do not repair

the pipe, but replace it.

1) only for Russia

B C

Important! When installation is complete,

make sure that the seal of each pipe fitting is

correct. Use a soapy solution, not a flame!

Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the burn-

er.

3. With a socket spanner 7 remove the injec-

tors and replace them with the ones which

are necessary for the type of gas you use

(see table in "Technical Information" chap-

ter).

4. Assemble the parts, follow the same pro-

cedure backwards.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply. You can find this plate in the

package supplied with the appliance.

If the supply gas pressure is changeable or dif-

ferent from the necessary pressure, you must fit

an applicable pressure adjuster on the gas sup-

ply pipe.

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the control knob.

4. With a thin screwdriver, adjust the by-pass

screw position.

A) The by-pass screw

• If you change from natural gas G20 20 mbar

(or natural gas G20 13 mbar

fully tighten the by-pass screw in.

) to liquid gas,