Zanussi ZGG62414XA Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Варильна поверхня Zanussi ZGG62414XA. Zanussi ZGG62414XA 16 сторінок. Product manaul
Також для Zanussi ZGG62414XA: Посібник користувача (49 сторінок), Посібник користувача (20 сторінок)

Друкувати сторінку

B C

A) End of shaft with nut

B) Washer

C) Elbow

Connection to the gas supply should be with

either rigid or semi-rigid pipe, i.e. steel or cop-

per.

The connection should be suitable for connect-

ing to R 1/2 (1/2 BSP male thread).

When the final connection has been made, it is

essential that a thorough leak test is carried out

on the hob and installation.

Make sure that the main connection pipe does

not exert any strain on the hob.

If you use flexible metal pipes make sure that

they agree to ISO 10380 and ISO 10807

standards. Be careful they do not come in

touch with mobile parts or they are not

squeezed. Also be careful when the hob is put

together with an oven.

Important! It is important to install the elbow

correctly, with the shoulder on the end of the

thread, fitted to the hob connecting pipe.

Important! Failure to ensure the correct

assembly will cause leakage of gas.

Important! Make sure that the gas supply

pressure of the appliance obeys the

recommended values.

Rigid connection:

Carry out connection by using metal rigid pipes

(copper with mechanical end).

Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the burn-

er.

3. With a socket spanner 7 remove the injec-

tors and replace them with the ones which

are necessary for the type of gas you use

(see table in "Technical Information" chap-

ter).

4. Assemble the parts, follow the same pro-

cedure backwards.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply. You can find this plate in the

package supplied with the appliance.

If the supply gas pressure is changeable or dif-

ferent from the necessary pressure, you must fit

an applicable pressure adjuster on the gas sup-

ply pipe.

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the by-pass

screw position.

A) The by-pass screw

• If you change from natural gas G20 20 mbar

to liquid gas, fully tighten the adjustment

screw in.

• If you change from liquid gas to natural gas

G20 20 mbar, undo the by-pass screw ap-

proximately 1/4 of a turn.

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the minimum

position.

Electrical connection

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.