Zanussi ZGG67412 Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Варильна поверхня Zanussi ZGG67412. Zanussi ZGG67412 32 сторінки.
Також для Zanussi ZGG67412: Посібник користувача (16 сторінок), Посібник користувача (16 сторінок)
Друкувати сторінку
Burner overview
A. Burner cap
B. Burner crown
C. Ignition candle
D. Thermocouple
Ignition of the burner
Always light the burner before you
put on the cookware.
WARNING!
Be very careful when you use open
fire in the kitchen environment. The
manufacturer declines any
responsibility in case of the flame
misuse.
1. Push and hold the spark generator button.
2. At the same time push the control knob
down and turn it counterclockwise to the
maximum gas supply position ( ).
3. Release the spark generator button when
burner lights but keep the control knob on
this position for equal or less than 10
seconds; this will let thermocouple to warm
up. If not, the gas supply will be interrupted.
Hints and tips
WARNING!
Refer to Safety chapters.
www.zanussi.com
4. Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and its
cap are in correct positions.
WARNING!
Do not keep the control knob
pushed for more than 15 seconds. If
A
the burner does not light after 15
seconds, release the control knob,
turn it into off position and try to light
B
the burner again after minimum 1
minute.
CAUTION!
C
In the absence of electricity you can
D
ignite the burner without electrical
device; in this case approach the
burner with a flame, turn the control
knob counter-clockwise to maximum
gas supply position and push it
down. Keep the control knob
pushed for equal or less than 10
seconds to let the thermocouple
warm up.
If the burner accidentally goes out,
turn the control knob to the off
position and try to light the burner
again after minimum 1 minute.
The spark generator can start
automatically when you switch on
the mains, after installation or a
power cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the off
position
WARNING!
Always turn the flame down or
switch it off before you remove the
pans from the burner.
.
7