Zanussi ZGGN645K Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Варильна поверхня Zanussi ZGGN645K. Zanussi ZGGN645K 21 сторінка.
Друкувати сторінку
WARNING: Unattended cooking on a hob with fat or oil can be
•
dangerous and may result in fire.
NEVER try to extinguish a fire with water, but switch off the
•
appliance and then cover flame e.g. with a lid or a fire blanket.
CAUTION: The appliance must not be supplied through an
•
external switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by a utility.
CAUTION: The cooking process has to be supervised. A short
•
term cooking process has to be supervised continuously.
WARNING: Danger of fire: Do not store items on the cooking
•
surfaces.
Metallic objects such as knives, forks, spoons and lids should
•
not be placed on the hob surface since they can get hot.
Do not use the appliance before installing it in the built-in
•
structure.
Do not use a steam cleaner to clean the appliance.
•
If the glass ceramic surface / glass surface is cracked, switch
•
off the appliance and unplug it from the mains. In case the
appliance is connected to the mains directly using junction box,
remove the fuse to disconnect the appliance from power
supply. In either case contact the Authorised Service Centre.
In case of hotplate glass breakage:
•
shut immediately off all burners and any electrical heating
–
element and isolate the appliance from the power supply,
do not touch the appliance surface,
–
do not use the appliance.
–
If the supply cord is damaged, it must be replaced by the
•
manufacturer, an authorized Service or similarly qualified
persons in order to avoid a hazard.
Where the appliance is directly connected to the power supply,
•
an all-pole isolating switch with a contact gap is required.
Complete disconnection in compliance with the conditions
specified in overvoltage category III must be guaranteed. The
earth cable is excluded from this.
When you route the mains cable, make sure that the cable
•
doesn't come into direct contact (for example using insulating
3