Zanussi ZGO62414BA Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Варильна поверхня Zanussi ZGO62414BA. Zanussi ZGO62414BA 17 сторінок.
Також для Zanussi ZGO62414BA: Посібник користувача (17 сторінок)

Друкувати сторінку

WARNING! When installation is

complete, make sure that the seal of

each pipe fitting is correct. Use a

soapy solution, not a flame!

ADJUSTMENT OF MINIMUM LEVEL

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the bypass

screw position (A).

WARNING! Make sure the flame does

not go out when you quickly turn the

knob from the maximum position to the

minimum position.

ELECTRICAL CONNECTION

•

Make sure that the rated voltage and type of

power on the rating plate agree with the voltage

and the power of the local power supply.

•

This appliance is supplied with a mains cable

and a plug.

•

Always use a correctly installed shockproof

socket.

•

Make sure that there is an access to the mains

plug after the installation.

•

Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug.

•

There is a risk of fire when the appliance is in

connection with an extension cable, an adapter

or a multiple connection. Make sure that the

ground connection agrees with the standards

and regulations.

•

Do not let the power cable to heat up to a

temperature higher than 90° C.

Make sure that you connect the blue

neutral cable to the terminal with a

letter "N" on it. Connect the brown (or

black) phase cable to the terminal

which has a letter "L". Keep the phase

cable connected at all times.

CONNECTION CABLE

To replace the connection cable use only the

special cable or its equivalent. The cable type is:

H05V2V2-F T90.

Make sure that the cable section is applicable to

the voltage and the working temperature. The

yellow / green earth wire must be approximately 2

cm longer than the brown (or black) phase wire.

ASSEMBLY

min. 100 mm

min. 55 mm

30 mm

min. 650 mm

550 mm