Zanussi ZGS 646X Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня Zanussi ZGS 646X. Zanussi ZGS 646X 16 сторінок.

Building In

This hob can be inserted in a built-in kitchen unit whose

depth is between 550 and 600 mm. The hob dimensions

are shown in the relevant diagram.

The edge of the cut out must have a minimum distance

from the rear wall of 55 mm.

If there are side walls, or sides of the furniture unit near

the hob, the cut out edges must have a minimum

distance of 100 mm.

Hanging furniture units or hoods must be placed at 650

mm. minimum from the hob (Fig. 8).

= Rapid burner

= Semirapid burner

= Auxiliary burner

Fitting the hob to the worktop

The hobs can be installed in a kitchen unit with an

opening for insertion whose dimensions are shown in

Fig. 8. To install the hob, proceed as follows:

1) Remove the pan supports, the burners caps and

crowns and turn the hob upside down.

2) Place the sealing gasket (supplied with the hob) on

the edges of the cut out: place it exactly on the front

and rear edge, taking care that the sealings meet

without overlapping;

3) Fix the hob with the relevant screws (Fig. 7). The

traction of the screws is able to trace the sealing, any

excess of which can be easily removed.

The edge of the hob forms a double labyrinth seal which

provides a total guarantee against infiltration of liquids.

a) Sealing gasket

Fig. 7