Zanussi ZGS 682 ICT Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня Zanussi ZGS 682 ICT. Zanussi ZGS 682 ICT 36 сторінок. Zanussi gas hob instructions booklet
Друкувати сторінку
Operation
Hob burners control knobs
Hob burners control knobs
Hob burners control knobs
Hob burners control knobs
Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
Lighting the burners
Lighting the burners
Lighting the burners
Lighting the burners
For easier lighting,
For easier lighting,
For easier lighting,
For easier lighting,
For easier lighting,
a pan on the pan support.
a pan on the pan support.
a pan on the pan support.
a pan on the pan support.
a pan on the pan support.
To light a burner:
turn the relevant knob anti-clockwise to maximum
position (
burner.
Only for model ZGS 682 ICT
Upon ignition, keep the knob pushed down
about 5 seconds
5 seconds
5 seconds. This will allow the
5 seconds
5 seconds
"thermocouple" (see diagram - letter D) to be
heated and the safety device to be switched
off, otherwise
interrupted.
Then adjust the flame as required.
If the burner does not ignite, turn the control knob
to zero, and try again.
If you cannot light the flame even after
severalattempts, check the "cap" (see diagram
- letter A A A A A ) and the"crown" (see diagram - letter
B B B B B ) are in the correct position.
8
proceed before putting
proceed before putting
proceed before putting
proceed before putting
proceed before putting
), then push it down to ignite the
the gas supply would be
Triple crown burner
A A A A A - Burner cap
B B B B B - Burner crown
C C C C C - Ignition electrode
D D D D D - Thermocouple (only in
model ZGS 682 ICT
A
B
D
C
)