Zanussi ZKL 64 N Інструкція з експлуатації та монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та монтажу для Варильна поверхня Zanussi ZKL 64 N. Zanussi ZKL 64 N 12 сторінок. Electric ceramic-glass hob
Друкувати сторінку
Installation instructions
The appliance must exclusively be con-
nected to the mains by an expert electri-
cian.
With the installation and in case of a service fai-
lure the appliance has to be isolated from the
mains. Fuselage to be switched off or removed.
The general rules for the operation of electric
appliances, the provisions by the competent
electricity supply board and the specifications
of these instructions for installation have to be
strictly adhered to.
Unpacking
Please do check whether the appliance was
STOP
delivered in perfect state. Appliances with
obvious transport damages must not be con-
nected to the mains.
Disposal
All packaging parts are recyclable, wooden
strips are non--treated, foils and hard foam
parts marked. Packaging material and old
appliances to be disposed orderly.
Do please adhere to the national and regional prescrip-
tions (material separation, waste collection, residuary
product yards).
Installation in the kitchen worktop
Electrical safety is to be ensured by professio-
nal installation.
Protection against accidental contact accor-
ding to the regulations set by VDE or other local
authorities and EN 60335 must be ensured by
correct installation of the appliances. The same
refers to the back of the appliance which, even
in case of built--in solutions away from the wall,
must not be freely accessible.
Built--in cupboards have to be located and
fastened in a way that they are stable.
Please write the „F.Nr." from the type plate of this hob
into the typle plate form on page 20. You need this num-
ber, when calling the after sales service.
Radius
R5
560 + 1
distance from worktop
opening to the rear wall
min 55 mm
19
Width
490 + 1
Depth
R5
Radius
20 mm
distance from worktop opening to
the left or right side wall or to a hig-
h cupboard
min 55 mm
20 mm