Zanussi ZFT710W Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Морозильна камера Zanussi ZFT710W. Zanussi ZFT710W 16 сторінок. Freezer
Також для Zanussi ZFT710W: Посібник користувача (41 сторінок)

Друкувати сторінку

1. Remove the plug

from the power sock-

et.

2. Tilt back the appli-

ance carefully so that

the compressor can-

not touch the floor.

3. Unscrew the left

foot.

Do a final check to make sure that:

• All screws are tightened.

• The door opens and closes correctly.

If the ambient temperature is cold (i.e. in Win-

ter), the gasket may not fit perfectly to the cabi-

net. In that case, wait for the natural fitting of

the gasket.

In case you do not want to carry out the above

mentioned operations, contact the nearest After

Sales Service Force. The After Sales Service

specialist will carry out the reversibility of the

doors at your cost.

Electrical Connection

Caution! Any electrical work required to

install this appliance should be carried out

by a qualified electrician or competent person.

Warning! This appliance must be earthed.

The manufacturer declines any liability

should these safety measures not be observed.

www.zanussi.com

4. Remove the lower

door hinge by un-

screwing the 2 retain-

ing screws.

5. Remove the hinge

pin from the bottom of

the door.

6. Slot the hinge pin

into the hole in the

hinge plate.

7. Take the door off.

8. Refit the upper

hinge pin into the op-

posite location.

9. Fit the door in place

on the hinge pin.

10. Slot the hinge pin

into the hole in the

hinge plate and relo-

cate the hinge assem-

bly to the opposite lo-

cation and refit using

the retaining screws.

11. Refit the bottom

hinge plate assembly

on the opposite side,

taking care that the

edge of the door is

parallel with the side

of the cabinet.

Important! The wires in the mains lead are

coloured in accordance with the following

code:

A Green and Yellow:

12. Remove and install

the handle (if fore-

seen) on the opposite

side.

13. Reposition, level

the appliance, wait for

at least four hours and

then connect it to the

power socket.

Earth