Zanussi GAS COOKER ZCG 641 Інструкція з експлуатації - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Кухонні плити Zanussi GAS COOKER ZCG 641. Zanussi GAS COOKER ZCG 641 20 сторінок. Zanussi cooktop user manual

Друкувати сторінку

Location of the appliance

This appliance must not be installed in a bed-sitting

room of volume less than 20m³ or in a bathroom, shower

room or garage. It is essential that the appliance is

positioned as stated below (see fig.1) i.e. shelves, wall

cabinets and cooker hoods must be fitted a minimum

of 787mm directly above the top of the hotplate and

400mm above the hotplate when fitted in line with the

outside of the appliance. If the units are intended to be

fitted adjacent to the appliance but less than 400mm

above the hotplate, then a minimum space of 100mm

must be maintained between the sides of the unit and

the appliance (see fig.). Curtains must not be fitted

immediately behind the appliance or within 150mm of

the sides of the hotplate. If fitted next to or between

two base units a minimum space of 1mm must be left

between each unit and the side of the appliance. The

levelling feet fitted to the appliance will achieve a

nominal height to hotplate trims of 900mm +20mm.

Installation

1. Positioning the Appliance

(Fig. 1)

Note A: The appliance is designed to be flush fitted with

2mm clearance at each side to allow for it to be pulled

forward for cleaning etc.

Note B: The hotplate side trims should be flush with the

cabinets and must not be below. Adjustable levelling feet

at the front and rear are provided on the base of the

appliance. Adjustment is obtained by rotating in or out,

the feet at the front or rear of the appliance from the

underside of the appliance, with the drawer removed.

A spirit level should be placed on a cake tray on one of

the shelves to confirm that the appliance is correctly

levelled.

The levelling feet fitted to the appliance will achieve a

height to hotplate trims of 900mm-0 + 20mm.

Note C: If the appliance is fitted next to a side wall or

cabinets above height of the hotplate trims, then a gap

of 115 mm is required.

Curtains must not be fitted immediately behind the

cooker or within 115 mm of the sides of the cooker.

Note D: Any wall cabinet or extractor must not be lower

than 780mm above hotplate level.

Note E: Wall cabinets may be fitted in line with the sides

of the base units, providing that the lower edge of the

wall cabinet is a minimum of 420mm above the worktop.

L.P.G. cookers MUST NOT be installed below ground

level, i.e. in a basement, or aboard any boat, yacht or

other vessel.

For appliances installed in the Republic of Ireland please

refer to NSAI- Domestic Gas Installation I.S 813 Current

Edition Section 7- Permitted Locations of Appliance.

Positioning the Cooker

Caution:

Some soft or badly fitted floor coverings can be

damaged when the cooker is moved across their

surface for cleaning. It is advisable to ensure that the

floor covering in the area below the cooker is either

securely fixed so as not to become damaged when the

cooker is moved or, if preferred, removed.

115

FO 1141

This appliance cannot be positioned on a

base.

The appliance can not be installed beside or between

furniture units whose height exceeds the cooker

worktop.

This cooker must only be installed by qualified

personnel, according to the manufacturer's instructions

and to the relevant British Standards.

Fig. 1