Zanussi SC9412 Інструкція по застосуванню та догляду - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція по застосуванню та догляду для Кухонні плити Zanussi SC9412. Zanussi SC9412 24 сторінки. Cooker
Також для Zanussi SC9412: Інструкція із застосування та догляду (24 сторінок), Посібник з використання та догляду (24 сторінок)

Reversible Main Oven Door

On some models the main oven door of the cooker can be changed from left to right hand

hinging, if required.

This is a reasonably simple operation if carried out in accordance with these instructions.

1 pozi-drive screwdriver and 1 small adjustable spanner are needed.

(i)

Open door wide and support whilst removing the two screws from the top L.H. hinge

bracket. Remove hinge bracket and place to one side. Having done so, the door can now

be lifted off the bottom hinge pin (A).

(ii)

Remove the eight screws that secure the inner door panel to the outer door panel, and

remove the inner panel being careful not to disturb the insulation material (B).

(iii)

The inner door panel can now be turned through 180°. The door latch roller assembly

will then be on the opposite end of the door (L.H.). Replace and secure inner door panel to

outer door panel (C).

(iv)

Remove button plugs and hinge bushes (top and bottom) and transfer positions (D).

(v) The upper L.H. hinge bracket (already removed) should now be transfered to the R.H.

lower position (E).

(vi)

Remove the door catch striker and plate from R.H. side of chassis (F).

Remove blanking screw from L.H. side of chassis (H).

Replace blanking screws to R.H. side of chassis.

Refit door catch and plate into opposite L.H. position (Do not tighten at this stage).

(vii)

The door can now be located onto the R.H. bottom hinge and held in place while the

R.H. top hinge is fitted to the door and then secured to the chassis.

(The R.H. top hinge is the same hinge removed from the bottom L.H.) (G).

(viii)

Final adjustment: With the door still closed the door catch adjustment is automatic

and can now be tightened from the side.

Open inner glass door to 90°and remove by lifting up and

out. Release the top hinge from the inside of the oven by

removing the two fixing screws. Remove hinge pin by

loosening the fixing screws, and replace into opposite end

of hinge, re-tightening the screw. Remove blanking screws

from holes in right hand side of oven, and using these holes