Alecto Hesdo DBX-90 Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Радіоняня Alecto Hesdo DBX-90. Alecto Hesdo DBX-90 7 сторінок.

Друкувати сторінку

(B) Receiver

1. Operation from battery pack

Press down the lock button, slide open the battery cover in the direction as shown.

Insert the supplied rechargeable Ni-mH battery pack into the compartment. Make

sure the two spring plates are in contact with the two terminals of the battery

pack. Install back battery door and belt clip. (It may be necessary to remove belt

clip when replacing battery pack, please refer to belt clip removal diagram in

OPERATION section).

2. Operation from AC mains using intelligent rapid charger

Connect the output plug of the supplied 9V AC adapter to the DC jack 16 of

the rapid charger, make sure the polarity is correct. With the battery pack installed

and receiver being switched off, place the unit into the rapid charger. The charging

indicator 14 will flash green and red alternately while detecting the battery status.

Adjust the position of the receiver in case the charging indicator 14 does not

light up. After a short while, the charging indicator 14 will flash red only, showing

the battery is under fast charging. Once the battery is fully charged up, the indicator

14 turns steady green. Now the receiver can be switched on for operation. Either

you can take out the receiver or kept placing it in the rapid charger will cause no

damage to the battery. In the latter case, when the battery is being consumed

and voltage falls to a certain level, the rapid charger will automatically start charging

up the battery again.

NOTE : Before using the receiver for the first time, charge up the supplied Ni-mH

battery pack with the rapid charger for at least three hours. Besure to switch off the

unit before charging.

CAUTION: BESURE THE BATTERY IN THE RECEIVER IS RECHARGEABLE TYPE BEFORE

PLACING IT IN THE RAPID CHARGER, OTHERWISE EXPLOSION MAY RESULT.

BESURE THE BATTERY IS INSTALLED IN THE RECEIVER BEFORE PLACING IT IN THE

RAPID CHARGER, OTHERWISE THE RECEIVER WILL NOT OPERATE NORMALLY.

Push until a "click"

sound is heard

CONTROLS LAYOUT

Transmitter

1. Power ON/OFF and night light switch

2. Up/Down button

3. Mode button

4. Night light

5. Condenser microphone

6. Power on indicator

7. DC jack

8. Power ON/OFF and vibration switch

Lower Temperature Limit

LCD

Upper Temperature Limit

Channel No. /

Baby's Room Temperature

Battery Status Indicator

Night Light Icon

Channel No. /

Baby's Room Temperature

Battery Status Indicator

Transmitter LCD Screen

Rapid Charger

Reciever

9. Up/Down button

10.Mode button

11.LED sound level meter

12.Speaker

13.Charging contacts

14.Charging indicator

15.Charging pins

16.DC jack

Out-of-range Icon

Vibration Icon

Transmitter Battery Low Icon

Digital Code

Speaker Volume Bar Graph

Receiver LCD Screen

Night Light VOX Icon

Transmit Icon

Range Check Icon

Digital Code

Microphone Sensitivity Bar Graph