Alecto WS-1550 Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Метеостанція Alecto WS-1550. Alecto WS-1550 8 сторінок. Weather station with wireless outdoor sensor

Друкувати сторінку

INSTALLATION

Indoor unit power supply:

Connect the supplied 4.5VDC power

adaptor (A) or insert the batteries according

to the instructions below:

1. Open the battery compartment of the

indoor unit by carefully pushing the

retaining clip at the rear downward (1).

2. Remove the battery cover and insert 3

batteries, type alkaline, size AA, 1.5V

(2), paying attention to the polarity.

Batteries are not included.

3. Click the battery cover back onto the

weather station.

As soon as the indoor unit starts up, the

weather icons start flashing in the display.

1. Press the UP and DOWN (11 and

12) buttons to select the icon for the

actual weather conditions. See also

'WEATHER FORECAST'.

2. Press the "CLOCK" (16) button to

confirm your selection.

Now the reception icon for the outdoor units

starts flashing, while the receiver for the

outdoor units starts receiving.

Outdoor unit power supply (D):

1. Open the battery compartment by

sliding the cover at the front downward.

2. Insert 2 batteries, type AAA, 1.5 Volt, as

indicated inside the battery compartment

(D8). Batteries are not included.

3. Press the TX (7) button to register the

outdoor unit. Upon leaving the factory,

the outdoor unit is set to channel 1 (9).

4. Replace the battery cover onto the

outdoor unit.

Now press and hold the Channel button

(15) for 3 seconds to start the reception of

the DCF-77 clock signal; the

starts flashing. The number of arcs shown in

the icon depends on how strong the signal

reception is.

The receiver operates for 10 minutes and

the unit then switches back to the reception

of the outdoor unit.

Attention:

Alkaline batteries will power the WS-

1550 approx. 4 months; that's why it's

recommended to power the WS-1550 using

the power adaptor and to insert the batteries

only as a backup.

Positioning tips:

•

Mounting:

In case of wall-mounting, the indoor and out-

door unit may be suspended from a single

screw (see B5 and C5).

General:

The actual indoor temperature with the hu-

midity, the actual outdoor temperature with

the humidity and the time are only displayed

correctly after both the indoor and outdoor

unit have been functional for several hours

and have not been moved. The weather

icon (25)

forecast will be displayed correctly after at

least 24 hours.

Never place the indoor unit in direct

sunlight and keep it away from heat

radiating objects (lights, heaters, etc.)

For a strong reception of the radio

controlled time signals, never place the

indoor unit next to large metal surfaces

or devices with strong electromagnetic

fields.

The outdoor unit is not waterproof. Al-

ways place this unit on a spot protected

against rain and wind.

The distance between the indoor and

outdoor unit should be no more than

30 meters

DISPLAYS (see fig. F)