Platform: DBALL2
Firmware: CHRYSLER7 Remote Start Ready Installation (RSR)
Feature and Option List
It is recommended to configure all the features and options listed below using the configuration tool found on the module
flashing page on www.directechs.com. The web offers more options; however, manual configuration of the features is possible
using the information on this page.
* Default option
Feat.
Operation
Flashes / Option
1. No RF Output* Module is connected to a remote starter using a standard installation.
RFTD Output
1
2. RFTD Output
Type
3. SmartStart
1. Driver priority* Unlocks only the driver door on first press and unlocks all doors on a second press within 5 seconds.
Unlock Driver
2
Priority
2. All
1. Disabled*
3
Heated Seats
2. Enabled
1. Disabled*
4
Defroster
2. Enabled
1. 32 °F (0 °C)*
Heated
2. 23 °F (-5 °C)
Seats/Defroster
5
Temperature
3. 41 °F (5 °C)
Control
4. Always ON
Heated Seats
1. High*
6
Temperature
Level
2. Low
1. Disabled
2. Safelock
Smart OEM
7
Alarm Control
3. Enabled*
Module is connected to an XL202 using an RSR or RXT installation (when available).
Module is connected to SmartStart using an RSR or RXT installation (when available).
Unlocks all doors on first press.
No operation.
When the feature is enabled, it will activate the Heated Seats and heated steering wheel.
No operation.
When the feature is enabled, it will activate the rear defroster and heated mirrors.
When Heated Seats or Defroster feature is enabled, it will activate the feature upon remote start when
temperature is below 32 °F (0 °C).
When Heated Seats or Defroster feature is enabled, it will activate the feature upon remote start when
temperature is below 23 °F (-5 °C).
When Heated Seats or Defroster feature is enabled, it will activate the feature upon remote start when
temperature is below 41 °F (5 °C).
When Heated Seats or Defroster feature is enabled, it will activate the feature at any temperature.
When Heated Seats are activated, they will be set to HIGH.
When Heated Seats are activated, they will be set to LOW.
The OEM alarm will not be controlled by DBALL upon remote start. No disarm or arm command will be
executed at the beginning or end of the sequence; it must be controlled by the Remote Starter.
Smart OEM Alarm Control will behave like a standard Safelock feature on a remote starter. It will
unlock at the beginning of the sequence, and relock after start and shutdown.
Smart OEM Alarm Control will synchronize with the OEM alarm so that it will disarm and rearm the
vehicle in the remote start sequence, only when required. The reason for this is, factory alarm control
must often be done by lock or unlock operation. This could create unnecessary actions on door lock
modules, such as the horn to honk. When possible, Smart OEM Alarm Control will monitor the alarm
and door lock status to detect if the disarm or rearm is required. If the vehicle is unlocked or is not
equipped with factory alarm, the disarm/rearm will not be executed. Smart OEM Alarm Control will also
monitor the remote starter actions so that the factory alarm control is not done twice. A remote starter,
for which the Safelock feature is active, will work perfectly with this option and will make it invisible to
the user.
Description
© 2016 Directed. All rights reserved.
Rev.: 20160610
Page 11
Друкувати сторінку