Alecto BW-70 Інструкція з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Підігрівач для пляшок Alecto BW-70. Alecto BW-70 13 сторінок.
Також для Alecto BW-70: Інструкція з експлуатації (17 сторінок), Інструкція з експлуатації (20 сторінок)
Друкувати сторінку
GB
– Read and save these instructions.
– Never use the unit without water in it.
– Do not move an appliance containing hot liquids.
– Do not immerse appliance, cord or plugs in water or other liquid.
– Place the Baby Bottle Warmer out of the reach of children and on a dry, non-
slip, horizontal surface.
– Close supervision is necessary when the unit is used near children.
– Do not let cord hang over edge of table or counter.
– Do not place on hot surfaces or in a heated oven.
– Test food on inside of hand before serving to ensure it is at a safe temperature
for your baby. If the temperature of the heated content seems too high on a
regular base, it is recommended to use less water in the container - take care
not to fi ll the container with more water than half the possible content. It is also
recommended to regularly remove the bottle and shake it thoroughly to
ensure uniform heating of the bottle contents.
– Only use the Baby Bottle Warmer when the ambient temperature is between
+7ºC and +37ºC.
– Change the water in the bottle warmer often for hygienic reasons.
Warming baby bottles:
1. Slide the control knob into position "0" (off).
2. Place the bottle in the container and fi ll the space between the bottle and the
inner container with water up to half the possible content.
3. Plug the Baby Bottle Warmer into the mains socket.
4. Slide the control knob into position " ". The indicator lamp " " lights to
indicate the heating operation.
5. After some minutes the milk will have reached just the right temperature for
your baby. The indicator lamp " " goes out and the indicator lamp " " lights;
the same time you will hear some beeps.
6. Slide the control knob into position "0" (off) and disconnect the Baby Bottle
Warmer from the mains socket.
7. Remove the bottle from the container and shake it a little to distribute the heat
evenly before you allow your baby to drink.
Warming baby food jars:
1. Slide the control knob into position "0" (off).
2. Remove the label and lid from the jar.
3. Place the jar in the container using the lifter and fi ll the space between the jar
and the inner container with water up to just below the top of the jar.
4. Plug the Baby Bottle Warmer into the mains socket.
5. Slide the control knob into position " ". The indicator lamp " " lights to
indicate the heating operation.
IMPORTANT SAFEGUARDS
OPERATION
10