Clarke CAT70 Інструкція з експлуатації та обслуговування - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та обслуговування для Шліфувальна машина Clarke CAT70. Clarke CAT70 17 сторінок. Heavy duty belt sander
Також для Clarke CAT70: Інструкція з експлуатації та технічного обслуговування (7 сторінок)
Друкувати сторінку
gum solvent oil, or failing this, the tool should be disassembled, thoroughly
cleaned, dried and reassembled. This is better left to your Clarke dealer.
3. After extensive use, remove the
inlet screen filter and flush out the
mechanism with gum solvent oil or
an equal mixture of Clarke air-line
oil and paraffin. Allow to dry
before use.
4. f the tool runs erratically or
becomes inefficient, and the air
supply is of good quality, it may be
necessary to dismantle the air
motor and replace worn or
damaged parts. You may prefer to take the tool to your Clarke dealer if
internal maintenance is required.
PERFORMANCE
Please note that factors other than the tool may effect its operation and
efficiency such as reduced compressor output, excessive drain on the airline,
moisture or restrictions in the air-line, or the use of connectors of improper size
or poor condition which will reduce air supply.
**Clarke Air Line Oil (part no. 3050825) is available from your Clarke dealer.
Your Clarke air tool has been designed to give long and trouble free service. If,
however, having followed the instructions in this booklet carefully, you
encounter problems, take the unit to your local Clarke dealer.
STORAGE
When not in use, disconnect from air supply, clean & store in a safe, dry place.
If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of
Clarke air line oil into the air inlet, and run the tool for 5 seconds in order to
lubricate the internal parts.
ACCESSORIES
A wide range of accessories is available including filter/regulators, lubricators,
high-pressure hoses (5 to 50 metres) etc. Contact your Clarke dealer for further
information.
ABRASIVE BELTS
Replacement abrasive belts are available from your CLARKE dealer:
60 grit (pack of 5) Part no. 3110751
80 grit (pack of 5) Part no. 3110752
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10