Aleko BSW08 Посібник із швидкого старту - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Гойдалка Aleko BSW08. Aleko BSW08 4 сторінки. Nest swing & glider

Anchoring Swing Set to the Ground

M6 BOLT 60mm (X4)

Step 1. Attach Ground Pegs to all 4 Nest Swing Bottom Legs using F6 fasteners.

Step 2. Place assembled Swing Set in desired location and dig a footing hole,

measuring 12" (30cm) Long x 12" (30cm) Wide x 20" (50cm) Deep, at the base of each

support leg.

Step 3. Prepare and pour concrete into the footing holes following concrete

manufacturer's instructions. Fully fill footing holes to be level with ground surface.

Step 4. While Concrete is still wet, angle Ground Pegs toward opposing legs at roughly

120-degrees, then insert Ground Pegs into concrete footing, making sure Swing Set

Bottom Legs do not sink below ground surface (utilize concrete set time information).

Use temporary support made from wood or other material if necessary to prevent

sinking (Fig. 5).

Swing Set will be ready for use once concrete is fully set and cured (consult concrete

manufacturer's instructions).

Fig. 5

visit us at www.aleko.com