Directed Electronics 1000 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Автосигналізація Directed Electronics 1000. Directed Electronics 1000 8 сторінок. Python code hopping high frequency 6/96 change model 1000 owner's guide

Друкувати сторінку

High Security Disarm

Your system includes a High Security Disarm feature. During the trigger

sequence, using the transmitter to disarm the system will only stop the trigger

sequence (the siren will stop and the parking lights will stop flashing). How-

ever, the system will remain armed and the doors will stay locked. This is

extremely useful if you must stop the system from sounding, but are unable to

check the vehicle visually. The trigger will stop, but the vehicle will remain

protected.

To disarm with the transmitter during a trigger, press button I on your transmit-

ter. The siren will stop sounding. Next press button I once more and the

system will chirp four or five times (reporting the trigger) and disarm.

Disarming Without a Transmitter

This feature allows you to disarm the system without the transmitter should it

be lost, damaged or disabled. In order to disarm without a transmitter, you

must have the vehicle's ignition key and know where the valet button is. Be

sure to check with the installer for the location of the Valet button.

Turn on the ignition.

Push the Valet switch within 15 seconds.

The system should now disarm. If it does not, you may have waited too long,

so turn the ignition off and on and try again.

IMPORTANT: The Valet

switch will not disarm the optional VRS

hidden VRS

arm/disarm switch must be used (see VRS

Silent Mode

To temporarily turn off the arm or disarm chirps, use Silent Mode

press button II briefly before arming or disarming, and the confirmation chirp(s)

will be eliminated for that one operation only. If you want the arm/disarm chirps

turned off permanently, your dealer can do this for you.

NOTE: The Warn Away

response to lighter impacts is bypassed if the system

is armed using Silent Mode™. This ensures that no chirps will be emitted by

the siren in an area you want chirp free. The system is still fully able to trigger.

Only the Warn Away

response is defeated.

feature. The

section.).

. Simply

G438.696

95G438.PM5

the key is turned off. Note: If the door is open when the ignition is turned

on, the doors will not lock.

•

Panic mode enabled/disabled with the ignition on. (Some states have laws

against siren capability in a moving vehicle).

•

Automatic Engine Disable (AED) on or off. The purpose of the feature is to

protect the vehicle from being stolen at all times, regardless of whether or

not the alarm is armed. If AED is programmed on, the starter of the vehicle

will be disabled 30 seconds after the ignition is turned off. Once the key is

turned off, the LED will flash slowly (one-half its normal armed rate) to

indicate the AED arming cycle. Thirty seconds later, the starter of the

vehicle will be disabled. To start the car, it will be necessary to arm the car

with the remote and then disarm it with the remote. It is also possible to

disarm the AED feature by turning the ignition key to the "run" position and

pressing the valet button once. AED is also disabled when in Valet

NOTE: This feature will only function if the FailSafe starter kill relay has

been installed.

•

Forced passive arming on or off. If your system is programmed for passive

arming and the forced passive arming feature has been programmed on,

the system will passively arm after one hour, even if a protected entry has

been left open. This feature is useful if a door has accidentally been left

ajar when leaving the vehicle. Forced passive arming ensures that the

system will be armed in every situation. NOTE: When the system passively

arms after one hour, the entry point that has been left open, and anything

connected to the same zone, is bypassed and cannot trigger the system.

However, the remaining inputs to the system are fully operational.

•

Siren tones and chirp volume. The output of the Revenger

siren consists of six different tones in sequence. Any of these tones can

be eliminated by your dealer, resulting in a unique, easily identifiable siren

sound. The siren chirps can be either full volume or 6 decibels quieter

than the full alarm blast.

mode.

Soft Chirp

G438.696

95G438.PM5