Alemite 9911-HA Посібник з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Водяний насос Alemite 9911-HA. Alemite 9911-HA 4 сторінки. High-pressure portable pump

Друкувати сторінку

SER 9911-HA

Assembly

NOTE: Refer to Figure 2 for component

identification on all assembly procedures.

CAUTION

Select a clean environment for all assembly pro-

cedures. Prevent contamination from foreign

material. Damage to components can occur.

Pump Assembly

IMPORTANT: Make sure to remove the

protective cover from the inlet of Pump

Assembly (3).

1. Screw Bung Adapter (6) into Cover (7).

2. Install Pump Assembly (3) into the Bung Adapter.

• Do not tighten the Bung Adapter at this time.

Cover Assembly

NOTE: The following procedures are

applicable to model 9911-HA only.

3. Install Grip (18) onto Handle (17).

4. Screw Nut (14) onto each end of the Handle.

5. Install the ends of the Handle into the Cover.

6. Install Lock Washer (15) and additional Nut (14)

onto each end of the Handle.

• Tighten the Nuts securely.

Revision (1-00)

Follower Plate Assembly

7. Place Follower Plate (11) onto the top of the product.

• With a wobbling motion, eliminate any air that may be

trapped underneath the Follower Plate. Force the

product through the hole in the center of the Plate.

8. Guide the Pump and Cover Assembly into the Follower

Plate and fit the Cover onto the container.

• Allow the Pump to descend to the bottom of the

container.

9. Secure the Cover to the container with Thumb

Screws (10).

10. Adjust the Pump upward approximately 1/4 "

(7 mm) from the bottom of the container.

• Make sure the pump is oriented properly.

11. Tighten the screw on the Bung Adapter securely.

Control Valve and Material Hose

IMPORTANT: Do not apply thread sealant to

the first two (2) threads of any connection.

Contamination can occur.

12. Screw the large diameter end of Adapter (4) [with thread

sealant] into the outlet of the Pump Assembly.

• Tighten securely.

13. Screw either end of Material Hose (5) into the Adapter.

• Tighten securely.

14. Screw the 1/2 " -27 end of Z-Swivel (20) [with thread

sealant] into the Material Hose.

• Tighten securely.

15. Screw the opposite end of the Z-Swivel [with thread

sealant] into Control Valve (19).

• Tighten securely.

Air Line Accessories

16. Screw Connector (2) [with thread sealant] into the air

motor inlet.

• Tighten the Connector securely.

17. Install Air Coupler (1) [with hose] onto the Connector.

18. Test/Prime the Pump assembly.

Changes Since Last Printing

Added Part Number 339118

High-Pressure Portable Pump

Alemite Corporation