Clarke CM1 Інструкція з експлуатації та обслуговування - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації та обслуговування для Водяний насос Clarke CM1. Clarke CM1 15 сторінок. Engine driven water pump

Друкувати сторінку

Pay particular attention to the following:

Use sealant on all threaded connections.

Always ensure the rubber seal is in place and correctly fitted.

Always use a flexible hose at the pump body connection, of at least

1ft (300mm).

Keep all pipes/hoses as short and straight as possible, and avoid sharp

bends.

If a flexible hose must he laid across a roadway, protect it with

planking. (Instantaneous shut off pressure, applied when a vehicle

runs across an unprotected hose, will cause "hydraulic shock", which

can damage the pump and/or the hose).

The suction strainer MUST be attached to the end of suction hose, to prevent

large stones etc., from being drawn up which could cause severe damage.

Keep the strainer clean. If it is likely to clog with dirt or debris, proceed as

follows:

a. Prepare a bed of stones on which to rest the strainer.

or b. Tie the strainer so that it stays off the bottom of the pit, pond or excavation.

or c. Tie the strainer inside a basket or bucket.

Remove the Priming Plug, on top of the pump case, and fill the pump and

suction hose with water, leaving no air gap.

Remember the pump is self-priming ONLY when it has been filled. Once filled,

a non-return valve will maintain water within the pump body should it be

necessary to stop the motor (for refuelling etc.). Priming is ONLY necessary

therefore when the pump has been drained.

Ensuring there is adequate drainage for the discharged water, attach the

discharge hose using a 25mm ID hose.

ALWAYS check to ensure the delivery hose is adequately supported, and

protected to avoid, for example, the possibility of vehicles passing over it,

which could damage both the hose AND the pump.

Properly fuelled and connected, your pump will run without attention for

approximately 45 minutes on a full fuel tank.