Clarke CSP1530 Інструкція з експлуатації та технічного обслуговування - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Водяний насос Clarke CSP1530. Clarke CSP1530 17 сторінок. 1530w sewage pump
Друкувати сторінку
ELECTRICAL CONNECTIONS
WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS
THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS
SUPPLY.
Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply
through an approved 13 amp BS 1363 plug, or a suitably fused isolator switch.
If the plug has to be changed because it is not suitable for your socket, or
because of damage, it must be removed and a replacement fitted, following
the wiring instructions shown below. The old plug must be discarded safely, as
insertion into a power socket could cause an electrical hazard
If the colours of the wires in the power cable do not agree with the markings
on the plug proceed as follows
• The BLUE wire must be
connected to the
terminal marked N or
coloured black.
• The BROWN wire must
be connected to the
terminal marked L or
coloured red.
• The YELLOW AND
GREEN wire must be
connected to the
terminal marked E or
or coloured green.
AN APPROVED RESIDUAL CURRENT DEVICE (RCD) WHICH HAS A TRIPPING
CURRENT OF LESS THAN 30MA MUST BE USED.
If you are not sure, consult a qualified electrician. DO NOT try to do any
repairs.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Plug must be BS1363/A approved.
Earth
(Green and
Yellow)
Neutral
(Blue)
Ensure that the outer sheath of
the cable is firmly held by the clamp
7
.
Always fit
a 13 Amp
fuse.
Live
(Brown)