Clarke HSE130A Інструкція з експлуатації та технічного обслуговування - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Водяний насос Clarke HSE130A. Clarke HSE130A 17 сторінок. Submersible pumps
Також для Clarke HSE130A: Інструкція з експлуатації та обслуговування (20 сторінок)
Друкувати сторінку
NOTE: When the pump is being used in a permanent or semi-permanent
installation, a check valve must be fitted in the delivery hose. Suitable
hoses are available from your Clarke dealer.
USING THE PUMP
1. Take all necessary precautions as described on page 4 before plugging in
the pump and switching ON. Where the pump is an automatic unit fitted
with a float switch, the pump will only run where there is sufficient depth of
water for the float to rise and activate the pump.
If the water is likely to freeze, the pump must be run continuously, otherwise
the pump must be removed from the water and stored in a frost free
location.
2. Never run the pump dry. Never run the pump with the body exposed for
more than 10 minutes.
3. When the water has been pumped out, disconnect from the power supply.
Avoid running the pump continuously.
AUTOMATIC THERMAL OVERLOAD
These pumps are fitted with automatic thermal overload protection. If the
pump overheats due to an obstruction in the pump, or pumping warm water
for example, it will shut off automatically. Switch the pump OFF and
disconnect from the mains supply. Check for blockages and allow the motor
to cool (at least 5 minutes) before attempting to restart, by which time the cut-
out will have reset.
ACCESSORIES
A wide range of accessories is available from your nearest CLARKE dealer, for
further information, contact your nearest dealer, or telephone CLARKE
International Sales department on 01992 565300.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8