Directed Electronics AS-2371TW-FM Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Пульт дистанційного керування Directed Electronics AS-2371TW-FM. Directed Electronics AS-2371TW-FM 18 сторінок. Two-way fm led automatic/manual transmission remote starter
Друкувати сторінку
b.
Once the key is in the ON position, press on the brake pedal to put the
transmission in gear. Pressing the brake pedal at this step will cancel the remote
starter takeover.
c.
Drive off.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as
that used for Ready Mode (page 7); at the last step, press the
the system and leave the engine running.
NEW FEATURE – Push-To-Start Idle Mode
This feature is a variation of "Idle mode", but made specifically for Push-To-Start vehicles, with
automatic or manual transmissions. (Consult your installer for availability of this feature.) Follow the
same steps as the normal Idle Mode procedure, except for when re-entering the vehicle while the
engine is running;
1.
Press unlock
2.
Open then close all doors.
3.
You have 1.5 minutes (or 3 minutes) to press on the brake pedal, to get in gear and
drive off.
Note 1: Pressing on the brake pedal after the allocated (1.5 or 3-min.) period will shut the engine
down.
Note 2: The engine will continue running until the user re-enters the vehicle or until the expiration
of the run time.
Note 3: If the pre-programmed run-time expires or if the user shuts down the engine remotely, the
vehicle will enter Ready Mode automatically (manual transmissions only).
Caution!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet Mode
When the vehicle is in Valet Mode, the remote starter and alarm functionalities are disabled. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from
being remote-started accidentally.
Any of the following features will put the remote car starter into Valet Mode:
Ignition Valet: This feature allows you to set Valet Mode using the ignition key.
Remote valet: This feature allows you to set Valet Mode using the transmitter.
Using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN and OFF positions 5 times until the parking lights flash 3 times.
2.
Turn the ignition OFF.
3.
The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Valet mode.
Using the TRANSMITTER (Remote Valet Mode):
1.
Press and hold the
then beeps once again. Release the buttons.
2.
The
and
3.
The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Valet mode.
User Guide
To put the system into Valet Mode
and
buttons simultaneously until the remote beeps once, pauses,
buttons will flash 3 times.
button to lock the doors, arm
P.9