Directed Electronics G4311A-AM15 AM15 Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Пульт дистанційного керування Directed Electronics G4311A-AM15 AM15. Directed Electronics G4311A-AM15 AM15 6 сторінок. Data start system for nissan with lcd 2way remote

Друкувати сторінку

Battery replacement

TRX722-2 transceiver

Slide the battery compartment door on back of transceiver.

(FIG.: 1)

Once cover as been removed, insert AAA 1.5v battery

(Make sure polarity is correct + / -)

Replace cover and check for operation.

Note: Normal battery life is approximately two years, but can vary depending on use. Change once a year for best performance.

Remote car starter indication

Remote started

Remote starter normally stop

Engine don't start

Hood open / Brake

Starting with Service mode activated

TRX722-2 Transceiver's functions

Lock:

Press one time on this button to lock all doors. The

parking light will flash once to confirm and this icon will

appear in LCD screen:

Trunk (if applicable and installed)

To open the trunk, press this button for 4

seconds and release. The parking lights will

flash 3 times to confirm and this icon will appear

in LCD screen:

ICON STATUS REFERENCE CHART

Lock/Unlock

Vibration

Confirmation

To operate two cars with the same 2way transceiver

While the

icon display on the LCD screen, you can remote control and communicate with a second vehicle security

system. (if both cars have the same system installed and tranceiver programmed by your installer).

1- Press and hold

2- Within 5 seconds, press

You can now operate the second vehicle previously programmed in your tranceiver.

* To operate car #1, redo steps 1 & 2, and the

Vibration mode

It is useful when you are in a noisy place and have difficulty hearing the beep sound from the remote control with the

tranceiver in this mode, tranceiver will vibrate if your security system is triggered.

1- Press and hold

2- Within 5 seconds, press

When an event happens on your vehicle, the tranceiver will vibrate instead of beeping.

* To return to beeping mode, redo steps 1 & 2, and the

System

Open hood

Open trunk

detected

buttons at the same time until one long beep is heard. Then, release buttons.

button once &

icon will appear on the LCD screen of tranceiver, in the middle of the car.

icon will disapear.

buttons at the same time until one long beep is heard. Then, release buttons.

button once &

icon will appear on the LCD screen of tranceiver, at the bottom of the car.

FIG.: 1

Lift cover

before

slidding

Parking lights

2 flashes

3 flashes

4 flashes

5 flashes

Unlock:

Press on this button to unlock all doors. The parking

lights will flash twice and the dome light will come

ON. This icon will appear in LCD screen:

Remote start:

Press once on this button and release. The parking

lights will flash to confirm the system received the

signal. Parking light will stay ON while engine is

running and this icon will appear in LCD screen:

To remote stop the engine:

Press on this same button once and release, the

engine will stop. The parking lights will flash twice to

confirm.

Open door(s)

Start

detected

successfully

icon will disapear.

Slide the door in this direction

Second car

Valet mode

Operation

G4311A

Timer Control

start

2007-12