Alemite 3624 Посібник з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Блок управління Alemite 3624. Alemite 3624 11 сторінок. Electronic-metered control valve

Друкувати сторінку

SER 3620

4. Remove V-Block (18) and Spring (20) from the Stem.

5. Unscrew Screw Assembly (24) from the Angle Body.

6. Remove Washer (23) from the Screw Assembly.

7. Remove Gasket (22) from the Angle Body.

Transmission Fluid Filter

NOTE: Refer to Figure 4 for component

identification.

1. Unscrew Spring and Adapter Assembly (29) from

Body (25).

2. Remove O-Ring (28) from the Spring and Adapter

Assembly.

3. Remove Stud (27) from the Body.

4. Remove Filter Tube (26) from the Body.

Item

Part No.

No.

Body

321191

Tube, Filter

Stud

X171001-14

O-Ring, 3/4 " ID x 15/16 " OD

Spring and Adapter Assembly

Legend:

Part numbers left blank are not available separately

Part number with an X prefix indicates a quantity of ten (10)

Figure 4 Filter Assembly 321203 - Exploded View

Revision (11-05)

1-800-548-1191-http://[email protected]

Description

Qty

Electronic-Metered Control Valve

Control Valve Handle

NOTE: Refer to Figure 5 for component

identification.

1. Unscrew Swivel Assembly (39) from Body (30).

2. Remove O-Ring (38) from the Swivel Assembly.

3. Remove Strainer (37), Compression Spring (36), and

Spring Support (35) from the Body.

4. Remove Small Compression Spring (34), Seal (33),

and Push Rod (32) from the Body.

5. Remove Screws (41) that secure Lever Assembly (40)

to Cam (43).

• Remove the Lever Assembly from the Cam.

NOTE: The Lever Assembly is serviced as

an assembly.

6. Remove the Cam from the Body.

7. Remove O-Rings (42) from the Cam.

8. Remove Roll Pin (31) from the Body as required.

Electronic Meter Assembly

Refer to section entitled Electronic Meter for

complete details.

Clean and Inspect

NOTE: Use a repair kit for replacement

parts. Make sure all the components are

included in the kit before discarding used

parts.

1. Clean all metal parts in cleaning solvent. The solvent

should be environmentally safe.

2. Inspect all parts for wear and/or damage.

• Replace as necessary.

3. Closely inspect the mating surfaces of all components

for any imperfections. Ensure a smooth and clean

contact is obtained when assembled.

Alemite LLC