Directed Electronics XPRESSKIT DLPKCHG1-CHRY2 Посібник з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільні аксесуари Directed Electronics XPRESSKIT DLPKCHG1-CHRY2. Directed Electronics XPRESSKIT DLPKCHG1-CHRY2 4 сторінки. Solex series upgradeable doorlock interface + 1st gen. sentry key transponder bypass
Друкувати сторінку
IMPORTANT VEHICLE INFORMATION:
Please note that this module is not
compatible with Mitsubishi built vehicles.
4 PIN DATA TO
DATA (D2D) CABLE
DLPKCHG1-CHRY2
IMPORTANT INSTALL INFORMATION:
- 3 or 5 turns of loop is required.
- You can program the transponder only once.
- Do not install on metal surface.
INPUT
(-)
*Brown
INPUT
(-)
*Green
INPUT
*Blue
(-)
(-)
OUTPUT
Violet/White
DATA
Violet
OUTPUT
(-)
*Pink/White
Pink
INPUT
(-)
*Orange
INPUT
(+)
*Red
INPUT
(-)
*Black
Programming
= These wires are not required
Button
when connected in D2D mode.
*Ground when running (status)
*Lock
*Unlock
Doorlocks/Alarm Activation
Data
*Door Sense Trigger
N/C
*Trunk
*(+)12 Volt Constant
*Chassis Ground
1
9
Diagnostic plug (Face view) Under
dash driver side Position 2
NOTES
- Doorlocks / Alarm system activation wire:
For Sebring & Stratus sedan: White/Dark Green at BCM
All other models: Light Green/Orange at BCM
- BCM Located Behind Fuse Box on Driver Side
Rev.: 20100224
Page 2 to 5
8
16
© 2010 Directed Electronics. All rights reserved.