Alemite 3575 Series Посібник
Переглянути онлайн або завантажити pdf Посібник для Вимірювальні прилади Alemite 3575 Series. Alemite 3575 Series 8 сторінок. Oil control handle with mechanical meter
Друкувати сторінкуIntroduction
Thank you for purchasing an Alemite 3575
series Control Handle complete with me-
chanical meter. It has been designed to accu-
rately dispense, measure and control flow of
engine oil, gear oil, automatic transmission
fluid, and anti-freeze/anti-boil fluids.
Please read and retain this instruction
manual to assist you in the operation and
maintenance of this quality product.
General Information
This manual assists you in operating and
maintaining your new oil control handle, and
the information will help you ensure many
years of dependable performance with trouble
free operation.
Please take a few moments to read through
this manual before installing and operating
your new oil control handle. If you experience
problems with this product, refer to the trou-
bleshooting sections of this manual. If you re-
quire further assistance please contact your lo-
cal Alemite distributor or authorised Alemite
service center.
Important Information
Read This Information Carefully Before
Use.
Your safety is important to us. Read and
follow all safety instructions.
Some of these instructions "Cautions" alert
you to the potential for personal injury.
"Notices" throughout this manual advise of
potential practices or procedures which may
cause damage to your equipment.
Do not install in a rigid pipe in-line system.
Do not install with a shut-off valve on the out-
let side of the meter. Damage may occur to the
housing cover.
Ensure all operators have access to adequate
instructions about safe operating and mainte-
nance procedures.
Form 671086
Oil Control Handle with Mechanical Meter
C a u t i o n
Do not point nozzle at yourself or
anyone else.
Do not exceed pressure rating of any
component installed in system.
Install an adequate pressure relief
valve for operator safety.
Operating pressure:
0-200 psi (0-13.79 bar)
Line pressure between pump and the
control handle trigger valve must not
exceed 1,500 psi (103 bar).
Do NOT modify the auto
non drip nozzle.
Failure to comply could result in
minor or moderate injury.
Part number
Alemite, LLC
167 Roweland Drive, Johnson City, Tennessee, 37601
www.alemite.com
mechanical meter (Model 3575-A shown)
3575-A
Quarts meter with rigid extension
3575-B
Quarts meter with flexible extensions
3575-C
Liters meter with rigid extension
3575-D
Liters meter with flexible extension.
3575-A
3575-B
3575-C
3575-D
Figure 1 Oil control handle and
Description
SER 3575-A
Initial release (10-15)