Alemite 7261 Посібник з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Кабелі та роз'єми Alemite 7261. Alemite 7261 5 сторінок. Cord reel with rv plug

Друкувати сторінку
SER 7261
See Fig. 3
1.
Remove power from reel.
2.
Remove access cover (8) from reel.
3.
Remove three wire nuts (10) securing input electrical
cable wires to collector ring assembly wires. Ensure that
bare wires do not contact each other or the reel super-
structure.
4.
Apply power to reel.
5.
Using a voltmeter, check voltage between black wire
(hot) and white wire (neutral). If voltage reading is cor-
rect (120 vac), proceed to step 6. If voltage reading is in-
correct, replace input electrical cable (refer to SERVICE
INSTRUCTIONS).
6.
Remover power from reel
7.
Using an ohmmeter, check continuity of output electri-
cal cord. If cord checks good, replace reel. If cord is
faulty, replace cord (refer to SERVICE INSTRUC-
TIONS).
8.
Replace access cover (8).
SERVICE INSTRUCTIONS
WARNING:
Remove power from reel before performing any of
the following procedures.
REPLACING THE INPUT ELECTRICAL
CABLE
See Fig. 3
WARNING:
Use only 10/3 cable.
1.
Remove access cover (8) from reel.
2.
Remove three wire nuts (10) connecting input electrical
wires (2) to collector ring ass'y wires.
3.
Unscrew elbow (1) from reel & pull out input cable
from main shaft & elbow.
4.
Feed input wires (2) through elbow (1) and main shaft.
5.
Screw elbow (1) into reel.
6.
Connect input wires (2) and collector ring wires together
using wire nuts (10).
7.
Assemble cover (8) to reel.
Alemite, LLC
1-800-548-1191-http://[email protected]
REPLACING THE OUTPUT ELECTRICAL
CORD
See Fig. 3
WARNING:
Use extreme caution, reel under tension. Avoid
releasing latch mechanism.
Use only 10/3 cable.
1.
Pull output electrical cable from reel until cable is fully
extended, then latch.
2.
Remove access cover (8).
3.
Remove two wire nuts (7) securing output electrical
cable wires (5) to collector assembly brush wires (6).
4.
Remove output electrical cable ground wire from ground
lug (9).
5.
Loosen U-clamp (3).
6.
Remove output electrical cable.
7.
Remove cable bumper (4).
8.
Remove 6" of output electrical cable outer jacket.
9.
Route cable through guide arm and U-clamp (3) then
through cut-out in spool.
10.
Tighten U-clamp (3).
11.
Using wire nuts (7), connect output electrical cable wires
(5) to collector assembly brush wires (6) as indicated in
illustration.
12.
Connect ground wire of output electrical cable to ground
lug (9).
13.
Using an ohmmeter, check for ground faults.
14.
Replace access cover (8).
15.
Release latch and wind output electrical cable onto reel.
16.
Install cable bumper (4).
4
Revision (6-05)