Alphatron Marine BASICTRIPLEPILOT Посібник з встановлення та експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з встановлення та експлуатації для Морське обладнання Alphatron Marine BASICTRIPLEPILOT. Alphatron Marine BASICTRIPLEPILOT 19 сторінок.
Друкувати сторінку3
INSTALLATION
3.1
Standard delivery materials
The hardware of a BASICTRIPLEPILOT comprises of:
Mounting frame display unit
❑
BASICTRIPLEPILOT display unit
❑
BASICREMOTE control unit
❑
Processor unit
❑
Feedback unit (with double potentiometer)
❑
Single Gyro (sensor)
❑
3.2
General terms for installation
Don't install pilot hardware parts along strong vibration locations, nor in direct sunlight or
places were oil vapour, moisture, high temperature or high concentration of dust is present.
For the dimensions of the various parts, check the available drawings.
Be sure, when installing the hardware, to keep a safe distance from any compass.
3.3
Placing the BASICTRIPLEPILOT
The system consists of a number of hardware units for which it is important to select a suitable
location. for the dimensions of the various parts, see the available drawings.
Display: The BASICTRIPLEPILOT can be installed in various different ways. The display unit is
flush mounted by default but a bracket mount housing is available. According to (rhine)
regulation requirements the display must be placed in plain view of the helmsman and must be
easy accessible. There are no restrictions regarding the length of cable between the display unit
and the processor unit.
Operating unit/steering lever: This unit needs to be installed so that the zero positioning of the
steering lever exactly aligns with the bow/aft axis of the ship's hull. For this unit also certain
general installation regulation apply and need to be followed.
Processor unit: To adjust the pilot settings easy access the processor unit is required, therefore
it should be Installed at an easily accessible location in the wheelhouse console.
Feedback unit: Depending of the type of propulsion a feedback unit may or may not be needed.
The default position of the feedback unit is near to the rudder(s). Check the drawing for more
details. During and after installation especially check the absolute free motion of the mechanical
link between the rudder stock and the feedback unit. Also be sure this link (in most cases a
ribbed belt and pulley set) is mounted fully horizontal. Don't place the pulleys (big one on the
rudder stock, small pulley on the feedback axis) further apart than approx. 50 cm. Be sure that
the tension spring (of the belt) cannot come into contact with either pulleys, choose the
installation distance and the length of the belt accordingly.
To avoid the belt of coming loose from the pulleys enough tension needs to be applied to the
belt. The coil spring provides for this if the length of the belt is cut to the appropriate length.
Manual BASICTRIPLEPILOT
BASICTRIPLEPILOT
version 1.3UK
Page 7 of 19