Directed Electronics Valet 9405T Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Автомобільна електроніка Directed Electronics Valet 9405T. Directed Electronics Valet 9405T 9 сторінок. Back up sensor

Друкувати сторінку

E E x x a a m m p p l l e e S S e e n n s s o o r r P P l l a a c c e e m m e e n n t t C C a a l l c c u u l l a a t t i i o o n n : :

1. Measure the mounting distance between the

proposed locations for sensor A and sensor D.

For this example (not to be used for your

vehicle) let's say that measures 48".

2. Then 0.3L is 0.3 X 48" = 14.4"

and 0.4L is 0.4 X 48" = 19.2"

3. Hence, the distance that sensor B is from

sensor A is 14.4 inches, and the distance that

sendor C is from sensor D is 14.4 inches. The

distance between sensor B and C will be

19.2".

N N O O T T E E : : These distances are approximate as mounting

locations have to be selected based on clearance behind

the bumper and any obstructions or bumper curvatures

on the surface of the bumper.

1. Verify that the size of the

supplied hole saw (18.5mm)

is compatible to the diameter

of the sensor by first drilling

a test hole in a scrap piece of

wood.

2. Install the sensor vertically,

the "up" sign must be on

upside.

4. Drill the holes in the bumper as indicated in

the diagrams above and install the sensors.

Sensors A and D should N N O O T T be mounted on

the curve of the bumper.

E E C C U U I I n n s s t t a a l l l l a a t t i i o o n n

sensor A

sensor B

sensor C

sensor D

N N o o t t e e : : Before drilling any holes ensure the the area

behind is clear of any electrical, hydraulic, or support

members, etc.

N N o o t t e e : : Wiring is shown and described is for a positive

reverse indicator system.

The ECU is water resistant, however, it is recom-

mended that the module be mounted in the trunk

compartment or for a truck in as much of a pro-

tected area as possible.

1. Use the 3-sheet metal screws to mount the

module.

2. Connect the white wire to reversing light(+)

7 7

ECU

GND

reversing lingt(+)

Mount ECU in trunk

for a truck in as much

of a protected

area as possible

Connect the white wire

to reversing light(+)

N9405T 11-05