Clarke EZ-8 Посібник оператора - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник оператора для Підлогова машина Clarke EZ-8. Clarke EZ-8 20 сторінок. Drum sander
Також для Clarke EZ-8: Експлуатація та безпека (2 сторінок)
Друкувати сторінку
- 1. Table of Contents
- 2. Operator Safety Instructions
- 3. Introduction and Machine Specifications
- 4. How to Transport the Machine
- 5. Machine Set-Up
- 6. How to Operate the Machine
- 7. Sanding Cuts and Sandpaper
- 8. Sander Adjustment Procedures
- 9. Routine Maintenance
- 10. Troubleshooting
- 11. Section II Parts and Service Manual
- 12. Assembly Drawing #1 11/01
- 13. Assembly Parts List #1
- 14. Assembly Drawing #2 10/01
- 15. Assembly Parts List #2 7/03
- 16. Wiring Diagram 9/92
Machine Set-up
To set up the machine follow this procedure:
1. Familiarize yourself with the machine. Read all
danger, warning, and caution statements as well
as the Operator's Manual. If operator is unable
to read English, have the manual explained
before operating.
2. Install handle and fasten latches. See figure # 6.
3. Insert control link into notch and slide collar to
pin. Raise sanding drum with control lever. See
figure # 5 & # 6.
4. Install dust tube. Tie dust bag over bell opening
of dust tube.
5. Connect the handle pigtail to the motor cord.
Align ground pin, insert and twist. See figure # 7.
6. To install abrasive on sanding drum equipped
with paper clamp: loosen screws to paper clamp
with a coin. Do not remove screws or clamp
from the sanding drum. Insert one edge of
abrasive under paper clamp. Rotate sanding
drum to wrap abrasive around drum. Insert other
edge of abrasive under paper clamp. Center
abrasive and take up any slack in the abrasive.
Tighten screws on paper clamp. Close drum
cover. See figure # 8.
To install abrasive on sanding drum equipped for
sleeve abrasive: slide abrasive over drum, center
abrasive, and close drum cover.
How to Operate the Machine
To operate the machine follow this procedure:
1. Set any exposed nails with a hammer and punch
to avoid encounter with sanding drum. Connect
the machine to an appropriate grounded and
fused circuit (power supply). Press the selector
switch to the start (S) position. Once started,
allow switch to return to run (R) position.
American Sanders EZ - 8 Sander Operator's Manual
Clarke
®
Figure # 5
Figure # 6
Figure # 7
Figure # 8
Page 7