CTEK ONYX Посібник користувача та інструкція - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача та інструкція для Автомобільний зарядний пристрій CTEK ONYX. CTEK ONYX 7 сторінок.

CHARGING PHASES

ONYX is a multi stage fully automatic charger.

Desulphation (Lamp 1, blinking)

Desulphation with pulses to recover sulphated batteries. Indicated by blinking lamp 1.

Start (Lamp 1)

Starting phase for charging. The starting phase continues until the battery's terminal voltage

has risen over a preset level. At this point, charging goes into the bulk phase. If the terminal

voltage has not reached the preset level within 8 hours, charging is suspended. The error mode

is indicated. This indicates a battery which is faulty or has too large capacity. If a large battery

is charged that has been severely discharged, it may be necessary to restart the charger after 8

hours. Start is indicated by lamp 1.

Bulk (Lamp 2)

Primary charging where approximately 80% of the charging happens. The charger delivers

maximum voltage until the terminal voltage has risen to the preset level. After a number of

hours, the charger goes on to the next phase, even if maximum voltage is not reached. Bulk is

indicated by lamp 2.

Absorption (Lamp 3)

Final charging, voltage is kept at the preset level. During this phase, the voltage is gradually

reduced. If the maximum length of time for Absorption is exceeded, the charger automatically

continues with Analysis. Absorption is indicated by lamp 3.

Analysis (Lamp 3)

Charging is suspended for a short period and the battery voltage measured. If it falls too

quickly, the battery is probably faulty. Charging is suspended and an error is indicated (lamp 0).

Maintenance charging - float (Lamp 4)

During the first 10 days of maintenance charging the battery is maintained with constant volt-

age, 13.6V. Float-maintenance is indicated by lamp 4.

Maintenance charging - pulse (Lamp 4)

Charging varies between 95% and 100%. The battery receives a pulse when the voltage drops,

keeping the battery in good shape when it is not being used. The charger can be connected for

months.

If the battery is charged and/or the battery's terminal voltage drops, the charger starts a charge

pulse until the voltage has reached the preset level. The charge pulse is then interrupted and

the cycle is repeated as long as the charger is in pulse maintenance phase. If the terminal

voltage drops even lower, the charger automatically reverts to the beginning of the charging

curve. Pulse maintenance phase is indicated by lamp 4. If possible, check the water level

in the battery.

ONYX is protected from being overheated. The power will be reduced if the ambient tempera-

ture is raised.

EQUIPMENT

ONYX is delivered with a set of battery leads with battery pole clamps and a set of battery leads

with eyelet terminals.