Clarke CCO14C Інструкція з експлуатації та технічного обслуговування - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Пила. Clarke CCO14C. Clarke CCO14C 17 сторінок. Abrasive cut-off saw
Друкувати сторінку
TO CHANGE THE SPACING BETWEEN THE FENCE AND VICE
1. Use the wrench provided to loosen
and remove the two fence bolts.
2. Adjust the fence to the desired
position.
3. Tighten the fence bolts securely
before use.
REMOVAL AND INSTALLATION OF CUTTING DISCS
WARNING: TURN OFF AND UNPLUG THE TOOL BEFORE MAKING ANY
ADJUSTMENTS OR REMOVING OR INSTALLING CUTTING WHEELS. BE SURE
THE TRIGGER SWITCH IS IN THE OFF POSITION.
Cutting discs are available from your Clarke dealer - Part Number: 6470800
1. With the motor arm in the 'UP'
position, rotate the blade guard
out of the way as shown.
2. Hold the blade and use the 8mm
hex wrench supplied to loosen and
remove the bolt in the center of the
cutting disc.
3. Remove the bolt, washer, outside
flange and old cutting disc.
• Make sure that the flange
surfaces are clean and flat.
4. Install the new cutting disc by
reversing the above steps.
• Do not overtighten the bolt.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10